tranny ID

Discussion in '94-04 V6 Mustang' started by dastang2, Jan 17, 2004.

  1. dastang2 Active Member

    Member Since:
    Dec 12, 2003
    Message Count:
    2,058
    Likes Received:
    0
    Trophy Points:
    46
    what 5 spd. is in my 95. will a t5 bolt in it's place if and when i drop my built up carbed 5.0 in.
    dastang2, Jan 17, 2004
    #1

  2. cts New Member

    Member Since:
    Feb 24, 2004
    Message Count:
    1
    Likes Received:
    0
    Trophy Points:
    0
    yea

    it is as far as I know the same tranny, that is 94-95. Just the 5.0 got better internal stuff, and it might have a different bell-housing not sure. I know that the 93 and lower are different. I am assuming that you have a 5-speed. If you don't I have seen articals on the web telling how to do that.
    cts, Mar 4, 2004
    #2

  3. dastang2 Active Member

    Member Since:
    Dec 12, 2003
    Message Count:
    2,058
    Likes Received:
    0
    Trophy Points:
    46
    it is a t5 but someone said it was a t45 so that is why i asked
    dastang2, Mar 4, 2004
    #3

  4. 98CobraClone New Member

    Member Since:
    Feb 28, 2003
    Message Count:
    636
    Likes Received:
    0
    Trophy Points:
    0
    whatcha gonna do with the EFI (intakes/EEC/wiring/etc)??????????
    98CobraClone, Mar 4, 2004
    #4

  5. dastang2 Active Member

    Member Since:
    Dec 12, 2003
    Message Count:
    2,058
    Likes Received:
    0
    Trophy Points:
    46
    well there has been a change in plans because i recently aquired an 89 notch with a lot of goodies minus a motor and tranny. so i have an 87 t5 and the motor i built to drop in it. the 95 will remain a daily driver.
    dastang2, Mar 4, 2004
    #5

Share This Page