tranny noise..

Discussion in '2.3L (N/A & Turbo)' started by Keasbey, May 2, 2006.

  1. Keasbey New Member

    Member Since:
    Jun 12, 2003
    Message Count:
    928
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Montreal
    I've got some weird noise coming from the bellhousing, a kind of " clack clack clack" noise...

    New pilot bearing, PP, clutch, Throw out bearing, clutch fork seems to be a little bit loose, but nothing awful..

    The noise is loud... and if I press the clutch it stops, and it's only doing it at idle/neutral..

    Any ideas?
    Keasbey, May 2, 2006
    #1

  2. snake109 New Member

    Member Since:
    Dec 2, 2004
    Message Count:
    64
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Austin TX
    mine does the exact same thing, i would like to know too
    snake109, May 7, 2006
    #2

  3. 19Stangnotch87 New Member

    Member Since:
    Oct 12, 2005
    Message Count:
    74
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    idaho
    well any ideas why the seal in the back of the transmision could be leaking? i have changed it like a week ago and went about 1 hr away from where i live and seems to be leaking again? any ideas why!
    19Stangnotch87, May 7, 2006
    #3

  4. Keasbey New Member

    Member Since:
    Jun 12, 2003
    Message Count:
    928
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Montreal
    hmm did you removed all dust and **** before putting the new seal?
    Keasbey, May 7, 2006
    #4

  5. 19Stangnotch87 New Member

    Member Since:
    Oct 12, 2005
    Message Count:
    74
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    idaho
    yea i cleaned it all very good. i was thinking maybe my driveline would be bouncing around and causing it to rip or something i just dont know what it could be.
    19Stangnotch87, May 8, 2006
    #5

  6. JosephB New Member

    Member Since:
    May 3, 2006
    Message Count:
    42
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Alabama...for now.
    tranny

    Check the bellhousing bolts, tranny mounts and the universal joints. make sure the four bolts on the driveshaft are tight.:flag:
    JosephB, May 9, 2006
    #6

Share This Page