Transmission mount installation question?

Discussion in '2.3L (N/A & Turbo)' started by Lex, Oct 21, 2004.

  1. Lex Founding Member

    Member Since:
    Mar 3, 2004
    Message Count:
    298
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Halifax NS. Canada
    Ok . I did have plans to drop a T-5 in my car (I have an POS A4LD), but the quantities are scarse right now. I need to replace the tranny mount. I can take a crowbar and pry the tranny right up to the floor. and I feel a thump sound everytime I give it gas or it shifts (not so bad). Whats the easiest way to replace it?

    Thank you
    Lex, Oct 21, 2004
    #1

  2. T3AL New Member

    Member Since:
    Oct 17, 2004
    Message Count:
    216
    Likes Received:
    0
    Trophy Points:
    0
    I would go with the T-5 plans
    T3AL, Oct 21, 2004
    #2

  3. 140cilx Founding Member

    Member Since:
    Sep 7, 2001
    Message Count:
    2,385
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    GA
    Just find a good salvage mount, unbolt the old one, install the new one. Support the tranny w/ a jack while doing so. Maybe I'm missing the point of your question.
    140cilx, Oct 21, 2004
    #3

  4. Lex Founding Member

    Member Since:
    Mar 3, 2004
    Message Count:
    298
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Halifax NS. Canada
    You nailed it. Thanks. I really really really rather wait until the T-5 swap, but its just getting tooo anoyying with the thumping.
    Lex, Oct 21, 2004
    #4

Share This Page