Xenonworx dual beam HID install help

Discussion in '2005 - 2009 Specific Tech' started by MUSTANGT281, Dec 20, 2007.

  1. MUSTANGT281 New Member

    Member Since:
    Dec 19, 2007
    Message Count:
    2
    Likes Received:
    0
    Trophy Points:
    0
    I got this kit the other day and it has a main wiring harness and it has three bare wires coming from it red,blue,white. I was told by American Muscle that those wires needed to be spliced in. The question is I don't know were to connect them to. :shrug: If you have any info or pics I would greatly appreitate it.
    MUSTANGT281, Dec 20, 2007
    #1

  2. plnfixr320 New Member

    Member Since:
    Jul 10, 2007
    Message Count:
    55
    Likes Received:
    0
    Trophy Points:
    0
    Installation Notes:

    The dual HID H13 kit for 2005 and newer Mustangs does not use a plug. The harnesses will have three wires: blue, white, and brown. These wires plug directly into the connectors.

    Blue Wire = High Beam
    White Wire = Low Beam
    Brown Wire = Ground
    plnfixr320, Dec 20, 2007
    #2

  3. MUSTANGT281 New Member

    Member Since:
    Dec 19, 2007
    Message Count:
    2
    Likes Received:
    0
    Trophy Points:
    0
    Thanks! I really didn't get to look at the wiring on the car because ford has it right now. I got the old puff of Blue Smoke after sitting for about two days crapola crapola
    MUSTANGT281, Dec 20, 2007
    #3

Share This Page