Search results

i have a 6.5 spacing on a 10.5 inch rim with a 315 which is a 12.5 in tire rubbed the quad shock so I flipped them around

mine would do that when I put a fuel pressure gauge on the car found no pressure when the car wouldnt start changed fuel pump havent had a problem since

I just bought those rims but polished last week with 275 up front 315 out back I just had to flip quad shocks around it looks like I might be able to go a tad wider next time

mine did the same changed the sensor its fine now

Check your grounds make sure you have one going to the body from the motor if that is good take the starter to autozone or some where else and let them test it

Did the same went to the dealer overheated on the way home pulled the car in the garage found the ground connector wasnt making a good connection took off fords stuff wired in a relay and put my own 50 amp fuse in with a switch wired the fan on high speed and I dont have any problems for over a...

I am not to fimilar with that tranny did you buy it new or used how many miles on it does that tranny have a bearing in the rear of it I had a tranny in a different type of car that did the same thing found out is was the bearing in the tail shaft

mine did something similar found out the fane control was no good check to see if fan comes on check connections first maybe water spraying on it hurt it

I have 245 on my 9 inch rims difinitely too small recieved the car that way will go bigger when they wear out:D

Thanks every one found a 1/8 pipe to a #4 braided line at speed shop:nice: :nice:

I am installing mechanical fuel pressure gauge is thier a special fitting for the fuel rail (stock) or is it a fitting I can get at the hardware store thanks

go to msd website they have dirrections there http://www.msdignition.com/pdf/6%20series/6series.pdf