Search results

is the mark independent?

I would go ahead and get the 05 seats . flip the seat over in your car and remove the rails with a 10mm, should be 4 of them. you should be able to drill new holes in either your factory rails or your new seats. I just installed aftermarket seats into my factory rails. easy and didnt cost 200$

that quarter is a hard fix but can be done. I would get sum rust rust-inhibiting primer and crome finder moldings. I body shop most likely would want to replace the quarter. otherwise a few years later you will have the same problem

I have done a complete interior swap from a 02 into my 2000 last month, the defrost wiring on a 2001-2004 runs through the cluster, the 99/00 doesnt, If your doing to cut the dash to install the double din I would leave the defrost were it is. either go head and intsll the new defrost button...

I had this same problem a weekago, I didnt know there was a thread on this. I used electronics cleaner on all the gearing, then used wd40 with a needle and syringe to lube the moving parts, works like new

Found the problem, 2 of the wires backed out, easy fix

I will, i rebuild the driver window motor last week, works good as new. I should post pics of that to

thanks guys, I will be buying a multi-function switch in the morning, the third brake light threw me for a loop. if its getting its power from different locations then that narrows it down. it hit 100000 2 months ago and nothing but problems since, I have rebuild the bottom end, the...

I think you are talking about the blower moter, turn you temp control to hot and see if it blows any air. remove blower motor, attack 2 scrap wires to your battery, strike the wires on the removed blower motor, if your motor turns its not the problem.

I have a 2000 gt mustang, bought the car in 2006, today I noticed the brake lights are not working, the flashers/headlight/parklights all work. the third brake light works when brake is applied. fuses as all in working order, cruse control works aswell. any ideas??