Search results

My fogs/grill delete/chin spoiler are all in good shape. I basically have a chip about the size of a dime in my paint. There is also a vertical indent about 4 inches long and not even a 1/4 inch deep on the passenger side of my bumper. The paint is also "cob-webbed" around the point of impact...

Sup Everyone, Unfortunately my Mach1 had a run in with some road debris on the highway sunday night. Going about 65mph I slammed into what looked to be a bouncing piece of wood. It basically chipped some paint and left an indentation on my front bumper. My question is...does anyone know if...

I second that!!! Also I really doubt you ran a 12.7 on DR's in your SS(I know it's possible but i doubt that YOU ran it) lets see you run that on the stock rubber....don't think so not happeing. Stock for Stock a LS1 and a Mach is a Drivers race in the 1/4 (slight edge going to the LS1).

No your an @$$ because you talk smack on the internet and can't back it up with 1/4 time slips or dyno sheets. Where are they!?

Sup All, Well its getting hot around the pennsylvania area now. So today instead of riding with the windows down(listening to the sweet exhaust note) I throw the A/C on.......20 minutes later the thing is still blowing heat. I haven't had my 02 GT for 2 years yet and only used the A/C...

I just recently had a fog light blow out. I ordered a new bulb over the net. However now that I have looked at it I noticed alot of water/condensation inside the fog light. Think Ford would repair this under warranty since it appears that the bulb blew due to water leaking through the seal?

The passenger side fog light just recently blew out. Only lasted about 16 months. I did a search on the boards and did not find too much about this topic. Do I have to replace the whole fog light assembly or can the bulb inside be replaced? If so does anyone happen to know the part number of...