Search results

I have been following the same article and planned on using it for a guide line in gathering parts for my build. Apparently the heads are not up to standards for their 347 build. They are cnc porting them, machining out the spring seats, installing larger springs, retainers and changing...

Guys be advised the Edelbrock E-Street heads are experiencing valve spring breakage, which Edelbrock tech, Ron attributes to users running Hyd roller lifters. I have a set of the heads not installed yet. I found out about the problems by a post on the Corral. After discussing this with Ron at...

The fan pulls more air than any I have used or seen. It also pulls a lot of amps. You will need a good relay and use 14 or better wire. I have not been able to figure out the low speed wiring. It also makes some fan noise, but it will cool. good luck, joe

I appreciate your military service, thanks. The best mod for 99 and 01 Cobras are gears. If you do a lot of highway driving I would go with 3.73 or 4.10s. If you are love to smoke in more than 2 gears go with 4.30 or more. The next best mod on my 99, for performance was a cat back. I used the...

The KB kit is nice, but expensive. It is complete. You will not be running to the parts house or ordering parts to finish the installation. You will need the 9 lb kit to get in the 425 rwhp range. Definitely go with the intercooled kit. good luck,

WHAT !!!!! It's just the thermostat. You may want to drill a small hole in the flange and orient it toward the top. Some stats already have this hole. In my F150 the gauge goes up and down a couple of times before the coolant temp is consistant.

Did you ever get a Kenne Bell for your Cobra ?

I got close. Made 406 rwhp with a 462 rwhp KB kit. I think they have one tech. He is developing all the 04 and 05 KB kits for all makes of vehicles. So far he is the only one responding to our problem. It is not too hard to figure out where we stand on the priority list. With a limited number...

Most of the Ford uppers have an email address, ie [email protected]. These may be available on blueovalnews site. Get someones attention and ask personally for Bill Franco to check out your car. Bill is no longer on the mustang program, but on some international job. If they say he is not available...

Hope you guys can dig in and get on the list. I have waited since 99 for this kit. I could gripe about the people, the timing, the excuses, the wait, the options, but in the end I would rather have a K B. I am not a racer, or in a horsepower race, I just want to feel that great low end grunt of...