Search results

cel One good all out blast down the freeway will make it come on :D

cc plates You need to find someone that knows the ins and outs of aligning a car. I didn't use Cc plates with Eibach sportlines. The first align I got was at NTB, had a lot of negative camber, tires went fast. Second was at a friends shop by someone who knew what they were doing. Tires...

mils It all comes down to how long you want to stare at the bright yellow check engine light. I lasted for about a month before I snapped. Might as well get either the splice or plug in ones so the check engine light can come on if theres a problem somewheres else. I assume you bought a...

shifter noise I'm going to get some tho. I still here that tranny racket.

shifter noise an offroad x will solve it to :D I can barely here the radio on the freeway.

Straight Shot Running this intake as your only mod. might not give you the power you are looking for. But add all the other goodies and it makes a difference. The only 4.6's that can get in front of me are the Blown and Nos powered stangs, the rest are in my rear view.

timing Just run the 91/93 and eliminate the pinging all together. The car will run better. If your gonna run a timing adjuster and bump the timing up past stock, your gonna have to run 91/93.

Straight Shot I had the same comment as well. I gave my denscharger away. With the mods I have, this was icing on the cake.

maf screws Vice Grips and some patience.

Here's what I was told on the straight shot w/ 85mm. Disconnect the battery to reset the comp. ( I do that anyways) and drive the car for 20 minutes or so after install, don't just start it to see if it runs then turn it off and go inside. I don't have any funky idol problems, my car doesn't...

The clamps are junk. Two broke on me and I wasn't even getting them tight.

Hooker headers I'm not sure what makes them diff. for an automatic. BBK long tubes don't allow you to remove the 5 speed tranny on 96/97 and up mustangs, bad news when time for a clutch job. Hooker headers do allow the tranny to come out. Good news on the 3650 owners since they...

Mac Intake Lots of people. Do a search on that intake, there are claims from 5 to 30hp. Every company selling it has something diff. on it. The only claim I've seen thus far is 5hp over your current current cold air intake. But without a dyno, it means nothing. I can tell you one thing...

I had my tranny replaced at 8k miles, 3rd-4th crunch, a bad one at that. I have 36k miles now, plagued with just cold tranny crunches from 1-2. I'm afraid to miss a shift, tranny might go boom now that warranty is out. I heard from a service manager that ford redesigned the syncros and they...

hp numbers Who can say either way without dyno before and after. I didn't do a before so I'm just curious what I make now. Chances are, like most people, its crank power. Not to the wheels.

cobra vs blown gt 20k for a 02 GT 4700 for KB is far cheaper than paying 35 grand for a 03 cobra.

Mac Intake Yes, its a PITA to install. I still can't get the heat shield to sit in there correctly. I see the top of yours sits against the car flush whereas mine doesn't. It would have been nice if Mac supplied both a bigger boot from throttle body to intake tube (for bigger throttle...