I had to get up at the butt-crack of dawn this morning to go to work. I ran out in the 10 degree weather and started my stang so it could warm up before I had to leave. Even thyough I let it run for like five minuets, it died on me before I got out of the driveway. The choke was closed and the engine flooded. I know you guys will probably laugh but I stuck a screwdriver in the carb to hold the choke open so that I could get my stang to start again. I have an electric choke on my carb but I have never hooked it up. I have some questions about how to wire it.
Do I just run a hot wire from like the ignition to one side and ground the other?
Do I need to add a resister or anything?
Would it hurt to put a switch in the circuit so I could leave it off during the summer or maybe run it on a timer so the choke is powered for only 5 min after the engine is started.
Thanks in advance.
Do I just run a hot wire from like the ignition to one side and ground the other?
Do I need to add a resister or anything?
Would it hurt to put a switch in the circuit so I could leave it off during the summer or maybe run it on a timer so the choke is powered for only 5 min after the engine is started.
Thanks in advance.