Running codes no code 67 but I’m not holding clutch down

[Creomod]

I’m trying to figure out why my car starts and dies right away. I was running codes and I just snapped I’m not getting code 67 anymore? I have never held the clutch down and always would get code 67 but now I’m not. This could be my problem maybe a fault in that circuit?

 

[Mustang5L5]

clutch switch and the NGS on top of the T5 are wired in parallel. Either clutch down, or T5 in neutral (assuming plug is connected) should eliminate the code 67

 

[Creomod]

clutch switch and the NGS on top of the T5 are wired in parallel. Either clutch down, or T5 in neutral (assuming plug is connected) should eliminate the code 67

lol I know that but what I’m saying is I did not get it and I’m not holding the clutch down. Can it be a fault on that wiring ?

 

[Mustang5L5]

Try it again but leave the trans in gear (engine off obviously) and see if you get it then.

 

[Creomod]

I also was wondering can a bad afr gauge sensor cause my car to start the die and cause it to read lean and run lean?