Meh,.....It's always been painfully easy w/ a string, a tape measure and two 24" framing squares.
And one additional evil assistant.
The strings are pulled taut from front to back parallel to the body to get a "forward direction" established.
The steering wheel gets centered, and the tires adjusted using the string as a reference measuring the front, and back of the tire as compared to their distance from the string.
Then,...Once a straight ahead posture is established,..One guy sits on one side w/ the edge of a framing square pressed against the tire sidewall, and the evil assistant sits on the other side doing the same thing.
A tape measurement is taken of the front leading edge of the framing square, and then compared to the measurement taken at the rear trailing edge of the framing square.
For instance... Front measurement 57.5 rear measurement 57.75. There is a difference of 1/4."
The tires are "toed in" 1/4 of an inch.
That means I'm backing the tie rods out enough to make the tires push out in front. I want to end w/ 1/8" toe in.
It takes only a couple of threads to back the front of the tires out 1/16,...because the rear of the tires are pulling in 1/16 at the same time.
The re-measurement equates to 57.562 F, 57.687 R difference being .125.
Good enough to get it going forward.
I measure how far it is from the center of the wheel center cap to a reference point at the bottom of the fender lip when the car is sitting at ride height.
Then jack the car up,..remove the tire, then jack the
LCA up until the center of the spindle gets to the measurement I took while the car was sitting at ride height. Then I put a magnetic torpedo level on the rotor hat, loosen the CC plate, and shove the thing fully to the rear, and pull it out laterally until I get the level to zero bubble.
Now the tire is straight up and down at ride height.
I lock that down,...and the car is close enough to get it to a front end shop. In my case it was close enough to only need a tiny toe adjustment.