I've been lazy lately. It's been difficult to get motivated to work on the car. I managed to get out there today and get a lot done.
I started by addressing a problem I've had for a while. I realized after moving the car that the welds from the torque box to the front of the rocker didn't take. I decided to cut that part off and clean it up since I knew it didn't take because the metal wasn't clean enough. I did this on both sides.
Getting the metal very clean resulted in nice welds with good penetration.
I started by addressing a problem I've had for a while. I realized after moving the car that the welds from the torque box to the front of the rocker didn't take. I decided to cut that part off and clean it up since I knew it didn't take because the metal wasn't clean enough. I did this on both sides.
Getting the metal very clean resulted in nice welds with good penetration.