Ok.. I need to see if anyone has some info on a couple intake vac lines.
Theres three main lines I'm conerned with. On the rear of the intake is a line that goes to the vac. distribution block. On the front are two lines, one that curves around the back and one other.
My question pertains mainly to the two front lines. Where do they go? heh. This engine is sitting in my F-150 and I wasnt the one that removed it from the Mustang so I've never seen it properly assembled and hooked up. I need to know where to put these lines..
I also have one other question.. Could the rear line that goes to the vac. distribution block be switched out with one of the main lines on the front of the intake? I ask this because in my truck the intake is actually backwards. I swapped it around so the T.B. sits on the driver side making it a hell of alot easier to route my intake and hook my throttle cable up.. problem is the rear lines are now in front which puts the line in a weird spot. I only ask this from an aesthetic point of view.. It just doesnt look good hooked up the way it is right now, I'm not overly concerned with it but was just curious.
Anyway, if anyone would tell me where the two rear lines are supposed to go I'd apprecite it. I'm pretty sure one is supposed to go to the evap canister thing but I dont know which one..
Thanks!
Theres three main lines I'm conerned with. On the rear of the intake is a line that goes to the vac. distribution block. On the front are two lines, one that curves around the back and one other.
My question pertains mainly to the two front lines. Where do they go? heh. This engine is sitting in my F-150 and I wasnt the one that removed it from the Mustang so I've never seen it properly assembled and hooked up. I need to know where to put these lines..
I also have one other question.. Could the rear line that goes to the vac. distribution block be switched out with one of the main lines on the front of the intake? I ask this because in my truck the intake is actually backwards. I swapped it around so the T.B. sits on the driver side making it a hell of alot easier to route my intake and hook my throttle cable up.. problem is the rear lines are now in front which puts the line in a weird spot. I only ask this from an aesthetic point of view.. It just doesnt look good hooked up the way it is right now, I'm not overly concerned with it but was just curious.
Anyway, if anyone would tell me where the two rear lines are supposed to go I'd apprecite it. I'm pretty sure one is supposed to go to the evap canister thing but I dont know which one..
Thanks!