Heading to the machine shop!!

[Redsnk95]

Finally the new project is getting some small progress. I am heading over to the machine shop tomorrow to drop off the block, crank, rods, pistons, balancer, flexplate to get it machined and assembled. The heads and new intake are currently at FTI for work. Man I am dying to get back out there!

 

[SublimeRT]

Nice. How many cubes is it gonna be? What heads/intake? Is it gonna be NA?

 

[Redsnk95]

352ci (4.065x3.4)..same heads as my old motor. Better intake and much stronger camshaft this time around. Yep still NA.

 

[Stopsign32v]

Why didn't you go 363 and be done with it and what intake are you running? A Vic Jr w/ elbow?

 

[Redsnk95]

I couldn't pass up on the deal on these particular pistons that I purchased. Victor Sr. intake setup for EFI and using a 4hole throttle body.

 

[Stopsign32v]

You're putting a Super Vic on that? Must not be a car you drive around alot. Should do good in the upper RPMs.

 

[Redsnk95]

LOL no this has been a track only car for years. Shift points will be around 7800 or so...converter will be around 6800 or so.

 

[YEAHLOH95]

that sounds awsome can't wait to see how it runs, fti is the way to go good choice.

 

[Redsnk95]

Lets hope so Troy. We'll see how it works out. Just got all the stock EEC wiring out of the car today, wasn't near as bad as I thought it would be.