Does '94 have a chin spoiler, stock?

  • Sponsors (?)


Matt's the man!:nice:
think i'll pick the the deflector pieces up the next time i'm at the dealer.
also need some axle housing bushings.
the kit is only $40 for both bushings,axle c clips,and friction modifier.
 
found the plastic air deflector at the JY today,$3.50.
it had part #F7ZB-8B384-AA.
came off a 94 v6 vert
no rubber deflector though:notnice:
put it on today.
heres a mini how to.

1.raise car.
if you are using the push pins and have stock springs,you may be able to skip this step.my car is pretty low,plus i wanted to change the oil.
i bought some ramps today at Pepboys,$32.00.
much eaiser than jack and jack stands.
DSCN1515.jpg


2.no deflector!
DSCN1514.jpg


3.heres the deflector.
it is attached to the core support by 4 plastic push pins.
DSCN1511.jpg

DSCN1512.jpg


4.put in position.
instead of the push pins,i used two bolts with washers and lock nuts.
i put the two in the center holes,and the plastic push pins at the ends,as there is no way too get the nuts in there.
DSCN1521.jpg

center
DSCN1517.jpg

end
DSCN1518.jpg


5.put car down,all done.
DSCN1523.jpg
 
My plastic air deflector is in with sheet metal screws that are the same size as the push pin holes. They've stayed on for years with no problems. Using screws of some sort will help keep the air deflector on if you scrape it over a speed bump or one of those concrete blocks in many parking lots.
 
ok, the air deflector came in today; only one day after ordering. Was told the push pins were discontinued; but they sent me to the body shop. Guy there was very nice, found 4 push pins of several sizes, went out to the car with me, and even helped place it and secure it.

Looks right. Thanks to everyone here for their help.