been a long hard day.i bet i hand each fender on and off at least 30 times each. a little welding , a little grinding and a whole lot of hammer and dolly work and they finally fit .the pass .side was the worst of the two and i think it came out the best .no bondo will be needed .driver side is not bad but it could be better .pass. side is a ford tooling and driver side is a Dynacorn. the Dynacorn fit up to the door a little better but it was flat on the top. i had to keep working the hood side to get a proper fit . the headlight buckets fit after i egged out the mounting holes .the hood fits very well and fits right up to the head light doors. i just need to fit the R model front valance and the body is done .