Search results

  1. R

    NEW WHEEL BEARINGS

    :shrug:Is there a certain brand of wheel bearings that is better than stock or most aftermarket bearings? If so what brand should I use? Also should I change out the bearings in pairs or is it ok to do just the one that goes bad? thanks.
  2. R

    BUILD OR BUY

    :shrug:I'm condemplating building up my stock bottom end and maybe even my heads. I'd like to see what you guys think. I'm going to try to squeez out 600hp, how or what should i do to achieve this. I am already at the limit with my stock bottom end due to the high compression I'm running. I...
  3. R

    looking for the best intank fuel pump for my 98gt

    :shrug:hey guys, i'm looking to replace my stock in tank fuel pump and my in line boost pump for a solid reliable high flow intank fuel pump to work with my 98gt's returnless fuel system. Currently I'm running 42 lb injectors w/my supercharger running @ 11 lbs. I would prefer a quiet one if...
  4. R

    will this hurt my #'s

    i just did a PI swap with comp cams and i'm wondering if these comp cams were the wrong choice to install? the cams are out 8 degrees due to VTP clearance i could of stuck with the stock PI cams but i'm not sure if i would of got more out of them due to degreeing them much closer than the 8...
  5. R

    help w/supercharger FORD SVT

    I'm looking at a Ford SVT supercharger for 96-04 but i'm not to sure of these as far as performance. So i'm wondering what these are good for as far as boost and durability. currently i'm running a powerdyne w/an 11 lb pulley but i'm at it's limits and i was told to look for something better...
  6. R

    seat problems

    Just got a set of Mach 1 seats for my 98 gt everything looks like it fits realy well in the car however the rear seat backs lock into position but do not waunt to unlock to fold the seat back down. Is there a way to adjust this? Also the power drivers seat has the 4 wire setup for the power...
  7. R

    need seat help

    :shrug:I just got a set of mach 1 seats for my 98gt the seat backs latch but do not like to unlatch to lay flat. Is there a secret to adjusting these to latch properly? I also need help with the wiring for the drivers power seat due to the plugs being different. any help would be awsome. all the...
  8. R

    crank or wheels????

    :eek:I know this has been asked many times but i just had a lot of work done to my car and i was expecting a lot more power out of my setup than i got. i have read and heard that the stock bottom end on my 98gt is good for 400-450hp but i'm confused is that rated at the crank or at the...
  9. R

    how much should i see??

    hey guys i droped off my 98 gt about 2 weeks ago for some upgrades and i should be getting it back this week some time but i'm curious as to what you might think on how much hp my car will make. so i'm putting in a 2200stall converter,trans cooler, pi intake, pi heads(only ported the exhaust...
  10. R

    to go 4 valve or not?

    i'm thinking about a 4valve swap. currently i have a gt w/aode and i'm wondering how difficult it would be to do the swap i'm no master tech. my car is supercharged pushing about 11 lbs, BBK 75mm throttle body, C&L plenum, 80mm mas, 30lb injectors w/diablo sport tune. i'm thinking i have...
  11. R

    should i close the gap??

    i was wondering if i close the spark plug gap a bit would i get better fuel burning from my supercharged 4.6? i was reading a couple different articles on supercharged stangs and i noticed that they closed up the spark plug gap some, i am still running w/stock gap. would this help with producing...
  12. R

    powerdyne pulley change

    i was trying to change my supercharger pulley, but every time i tried i could not stop the pulley from rotating when trying to loosen the bolt. anyone have any ideas w/out takeing the charger off?
  13. R

    my car is sounding like a truck

    well the past week my car is getting louder and louder it sounds like something in the rear end. itsounds like someone put truck tires on my car, the only thing is these tires have been on my car for 2 1/2 years and never sounded like this. i have no idea what it is but when i go faster the...
  14. R

    how much more power can be exspected?

    ok, i know this has been asked a million times,i have a set of pi heads w/comp cams 270's and bee hive springs now i was thinking of getting the heads ported and polished. i waunt to keep it street worthy i would be interested in seeing what you think about how much more power that i might be...
  15. R

    window switch

    :nice: :SNSign: on the driver side does the window switch when put to the down position automaticaly go all the way down w/one touch.
  16. R

    race fuel

    :SNSign: how much of a gain would one get running race fuel & is it bad for the car?:nice:
  17. R

    when degreeing cams

    :SNSign: :nice: can anyone tell me if before i change my heads and intake if i have to set my timeing back to zero (tdc) ? i know that i have to degree my new cams and i just don't know if it matters seeing how degreeing the cams is resetting to tdc w/the new cams anyway.
  18. R

    ERROR#2

    :nice: :SNSign: :nice: ok, today i went to circut city to buy one of those cassett due-hickies to hook-up my M-p3 player through my factory radio. now when i put the cassett into the radio the radio showes ERROR #2 (what the hell is that!) and will not play the cassett only the radio. has...
  19. R

    will these work w/stock shocks & strutts

    :SNSign: i had bought a set of used eibach sportline springs. i was told that these will drop the car 2", but i'm concerned about how the shocks & strutts will hold up w/these springs. does anyone know if these springs will work w/factory springs and shocks???:nice:
  20. R

    5 or 6 quarts

    ok, i know this is a retarded question that has been asked over and over again, but does the stock 4.6 take 5 or 6 quarts of oil? i did something that i never do i went to jiffy lube for an oil change. i went for a full synthetic oil change which was $59.99 for up to 5 quarts, but when they...
Top Bottom
Back
Forums
Menu