Search results

  1. S

    Engine Build up

    Putting a motor together for the eventual completion of my project. So far it's a 05 Ford Racing block with hypatech forged pistons, E303 cam with Edelbrock Performer RPM heads and intake with a holley 650 double pumper. Got all the parts at a good price, but not sure what type of power I'll...
  2. S

    Did Cobra actually offer this?

    This is for sale locally and not sure if they were an actually aftermarket option for mustangs. REDUCED!!! Rare, factory 289 302 351W Dual 4V intake system I asked for date codes etc. and got the following response. "There are no part numbers on the COBRA intake, this is quite common...
  3. S

    First Step

    I am hopping to finally start some work on my mustang this fall. I was looking for suggestions on where to start. I have already stripped most of the interior. Next is to finish removing the rest of the interior and then the engine and trans. I was planning to send it out for media blasting...
  4. S

    82 GT

    I was looking for a little help in what you think she is worth. I'll post a link to the add. It converts to just over 75k for miles. I asked him about rust and he indicated that the bottom of the drivers door is starting to rust on the inside and the bottom of the rear wheel well is starting...
  5. S

    91 Mustang Interceptor

    Never heard of it but then again I don't know much about fox bodies. My current is a 68 Mustang in pieces. Do you think it's worth it? Not much info so far but have email in to try and find out more. 1991 mustang interceptor
  6. S

    Golden Nugget Specials

    There is a registry that appears to be starting up for these mustangs. Uncle Bill's Garage - Home
  7. S

    Length of Resto time?

    I was curious as to how long it took some of you to get your cars road worthy? I have to replace my front floor pans, the bottom right rear quarter and inside trunk to fender metal as well as the front right lower quarter. I also have to paint her, install the new vinyl roof, headliner and get...
  8. S

    Build Sheet

    I contacted Ford Canada to look up the build sheet for my car. They got back to me about 3 months later only to tell me that unfortunatley they don't have any records for my VIN. I turns out I wasn't the only one. He indicated three of the 5 request on his desk came back with no records. I...
  9. S

    Floor Pans

    Got the interior out on the Nugget and it wasn't as bad as I thought. I will need front pans and torque boxes as I originally expected, plus the sub frames under the pans. The good news is the frame rail. It looked like the drivers side was rusted through from underneath but it's in great...
  10. S

    Engine Compartment Light

    I appear to have a light attached to my hood for the engine compartment. It is a green and yellow wire that runs from the hood to one side of the starter solenoid. Does this make sense to anyone? Was this light even avaliable is 68? Thanks again for all your help. Scott
  11. S

    Testing Oil Pressure

    I know that in automotives we tested oil presure by removing the distributor and running the oil pump with a drill. I am wondering if you can do that with the 289 and if so what is the best set up. Thanks for the information. It's been along time and having a hard time remembering all the...
  12. S

    MIG Welder

    I am looking for information regarding MIG welders. I am thinking of buying a 115volt welder for working on the car but not sure if it will be enough. Any info would be appreciated.
Top Bottom
Back
Forums
Menu