Search results

  1. GToddyT5

    CARFAX Please!

    Could someone run a VIN for me on CARFAX? Thanks. WDBRF40J55F655053 [email protected]
  2. GToddyT5

    98 Cobra...MIL issues

    I'm getting codes P0135 and P1132. P0135 being an O2 Sensor heating circuit malfunction (Bank 1, sensor 1) and P1132 is a Fuel Air Metering malfunction. What seems to be the problem here? I've already replaced that O2 sensor and the MAF.
  3. GToddyT5

    Improper subframe connector installation

    I had subs welded on my car about two years ago. The installer welded them on lift that raised the car by the frame and not the wheels. Now, a few years down the line, the doors are more difficult to open and it seems like I have some spaces where I didn't before. It seems as though the...
  4. GToddyT5

    Driveability issues...

    My idle has been hanging for the past month. I've had an MIL light, code was for the driver's side front O2 sensor. That was replaced but the light came back and driveability didn't change. I do have an aftermarket catted X-pipe. I just replaced the battery last night and now the car has...
  5. GToddyT5

    Can an exhaust leak cause the computer to throw an O2 sensor code?

    I had a bad O2 sensor code, so I replaced the sensor. Then I cleared the codes and it came back. Could I have an exhaust leak at my midpipe?
  6. GToddyT5

    Can I reach driver's front O2 sensor without unbolting pipe?

    Is it possible for me to change out the driver's side front O2 sensor without unbolting the pipe? I don't have enough tools to unbolt the pipe.
  7. GToddyT5

    Fuel float/ gas guage issue

    I replaced my entire fuel sending unit (stock replacement) over the summer and the gas guage has read incorrectly ever since. The minimum it will read is a little bit greater than a quarter of a tank. Can I fix this without dropping the tank again? I don't want to take those fuel lines off...
  8. GToddyT5

    98 Cobra: What is different about the fuel pump assembly from 96-97

    I need to replace my whole fuel pump assembly including the sending unit, but I was wondering what they changed in 98. All I see are pumps for 96-97, but nothing for 98. Do I have any choice but to order the parts from the Ford dealership?
  9. GToddyT5

    Need dimensions--2000 Mustang

    2000 Mustang, don't have access to a car right now to actually take the measurements. How can I get the distance from the front bumper cover to the center of a rim? Anyone know? Even a fender and bumper cover dimension would help.
  10. GToddyT5

    SLP X-pipe...can I use a different brand of cats?

    I won an auction for a catted SLP X-pipe for a 98 Cobra on Ebay. They sent me a shorty pipe instead. I was pissed off and they ended up refunding my money and letting me keep the pipe. Now I need cats and the tubes in front of the cats. Do I have to use SLP cats or can I get something like...
  11. GToddyT5

    Why are there no good threads about convertible tops and sealing?

    I have a convertible top leak in multiple spots. It doesn't seal well near the back of the driver's side window and somewhere back near the rear glass. I get a decent amount of water in the basket behind the seat. I've done a lot of searching and can't find any good threads related to...
  12. GToddyT5

    Am I crazy??? My friend claims he can build my car for $6000.

    In a nutshell, this is what's in my engine bay: B50 Sportsman block 302" stroked to 317" 4340 Crank, forged H-beam rods, forged JE pistons, O-ringed, custom Comp blower cam, ARP hardware throughout, AFR 165s, Cobra intake, 42 lb injectors, intercooled P1-SC w/12 lbs of boost These are the...
  13. GToddyT5

    Starting car after three months of being idle...what should I know?

    I haven't driven the GT in about three months. Is there anything I should do before starting it up? I just got a new battery and my alternator tests good. Is there anything I should put in the fuel? Total, it has been driven three times since early December.
  14. GToddyT5

    What can I use to clean terminals?

    I fried the alternator boot on the terminal on the back of the alternator. The burnt rubber gunked the terminal all up. I've already used a wire brush on it, but there's still a bunch of stuff on there. What else can I use to clean the terminal? And has anyone replaced that wire before? I...
  15. GToddyT5

    Stock alarm: are there different modes?

    It seems like when I disconnected the battery the alarm went into a more promiscuous mode. I don't remember it auto-setting when I left the door unlocked and stuff like that. It's really annoying. Is there any way to change this? I didn't see anything in the manual.
  16. GToddyT5

    Anyone have the halo headrests on an SN95???

    Could you post pics if you do. I was thinking about these.
  17. GToddyT5

    Popped the cherry

    My Cobra got her first performance mod (by me anyway). I got the Kenny Brown zinc plated subs welded on yesterday. I was surprised by a lot of those who say it's a night and day difference. It really isn't, but the car does feel a little more stiff and stable. To come: MGW shifter, hi flow...
  18. GToddyT5

    Running speaker wire

    How hard is it to run new speaker wire? I want to go with components in the doors and poss in the rear (although I'll prob just run regular Infinity Kappa 5x7s). Where should I stick the four crossovers?
  19. GToddyT5

    Is it impossible to find a good deal on an MGW shifter???

    For as popular as these things are, there seem to be very few dealers, or anyone selling them for less than $180.
  20. GToddyT5

    How much can I get for my 95 GT come spring time?

    I don't really need/want my GT anymore...it just sits there. The Cobra is hella slower, but I don't have much of a need to go fast anymore. How much do you guys think I can get for my GT? 103k on chassis, about 10k on forged block, 20-30k (??) on blower and receipts for all work ($10K+)...
Top Bottom
Back
Forums
Menu