Search results

  1. P

    Tips and Tricks for installing Motor Mounts...

    Ive done it once, with the motor out. Super simple. But whats the best way to address this w/o pulling the motor...or is that not an option? Thanks...
  2. P

    t

    test
  3. P

    Nology Spark Plug Wires...Worth $200?!

    http://www.nologyhotwires.com/ Anyone ever coughed up the 2 bones for these? Are they really worth the money or is it a gimic?
  4. P

    Spark Plug confusion

    I pulled Autolite 764s out of my GT-40P heads. But i went to the parts store and they searched for 98 explorer it showed the 764s and then NKGs R-55s i think....so i went with the NGKs. The Autolites looked like the bottom right picture, and NGKs like the bottom left.....Now my car has a...
  5. P

    Carb Noise...Hissing/Gurgling...

    Almost all done with my Carb swap. Got all the fuel FINALLY Plumbed tonight. when i hit the key Fuel pressure jumps up to 6psi, then i can hear in the carb a gurgling/passing air noise (hissing). When I hit the throttle i see fuel going in the carb. But what is this gurgling i hear? Fuel...
  6. P

    Carb Throttle Cable...

    I'm in the middle of my EFI to Carb swap. And I priced throttle cables at the parts store and the Auto is cheaper than the 5 Speed Cable(for an 85 Stang is what I searched Under). Which one do i need? I have a 5 Speed Car, but it was orignally an AOD Car. They didnt have them in stock but...
  7. P

    Getting ready to make my Order from Summit for my EFI to Carb Swap...

    I've done quite a bit of research the past few days, read the pros and cons, read the rants and praises from others. And i'm down with the funky sound of going Carb. I've got a few questions/open for suggestions i still have out there.... You can see my current setup in my signature for...
  8. P

    What is this?

    Right behind where the driveshaft bolts up, on either side you can see bolt holes where like a brace bolts around the housing. My 'brace' was hanging lower on one side than the other and was loose. Tried tightening the bolts no avail...took it off and it looks as if it serves no purpose. I...
  9. P

    Southern Georgia?

    I"m Down in Valdosta Georgia. See a few Fox bodies running around once and a while not to many thought. Anyone else somewhere close to get together one weekend and cruise to the beach or try to get a little meet set up.
  10. P

    Fuel pump relay getting hot?

    Started off one day i ran my car out of gas idleing in the driveway. Fuel pump started sounding a little sick while priming after that. One day i go out to start it up and no pump prime. Go through the basics, inertia Switch good, replace relay, yadda yadda nothing. Jump the pin on the EEC...
  11. P

    Hot starts...

    I've had this problem ever since i got it out of storage. It starts fine when the car is cold. But once its been running a while up to operating temps when u shut it off...it starts slow like the batt is weak or wont start at all but once it hits the end of its trying to start and your still...
  12. P

    Workin on a Tattoo Idea...

    This is my first, and as everyone seems to say not my last tattoo.. Im workin on trying to find the mustang pony but with the american flag inside of the horse....I've found a few on the internet but they look horriable. Bc People cut out the inside deal of the horse and just put the flag...
  13. P

    Engine Ground Strap and Wire Harness ground...

    Do these two ground connect to back on the block on the driver side....i know the Strap does but do you put the harness ground there also? or does it have its own spot?
  14. P

    Need help Upgrading Up Grades...

    Well this past winter i cracked my upper intake by letting a friend help with the install and he over tightened a bolt and cracked it....so now i'm in the market for a new intake with the help of his wallet...and some of mine...Just need help on deciding what to replace it with.... Looking at...
  15. P

    Engine Ground getting Hot

    my car doesnt like to start when hot... IE: http://forums.stangnet.com/showthread.php?t=569033 so i replaced the webbed stock engine ground with a 6ga wire, and its getting REALLY hot after driving the car...and its not from under hood heat...its hot to touch...
  16. P

    Starting Problems

    The car sat in storage for 9 monthes, brought it out fired up like a champ. Then after that once it gets hot it doesnt like to start. I replaced the batt, starter, and starter solinoid. And trouble shot this much....batt reads 12.66V, Starter solinoid reads 12.66Vs ( Trunk Mounted...
  17. P

    Mustang Week!!

    Whos Going? I'm going down friday afternoon, and coming back Saturday, just to check it out.
  18. P

    Gear INstall in Eastern NC

    I normally goto Fastlane motorsports for all my upgrades. BUt there closed next week do to Mustang Week in Myrtle Beach. Well i'm only home for 2 weeks and want to get my gears installed while i'm home. Problem is i dont know where else to go? Maybe a dealership? And it would be kinda...
  19. P

    Milky Oil...Lower not sealed?

    I just pulled my engine out last week replace all the gaskets except Head gaskets cleaned it all up and put it back in... Just changed my oil after about 100 miles...and its got some milky spots in it. Is this from my lower intake not sealing correctly?
  20. P

    Spark Plug Wire Condoms...

    I have two on my back two wires on the passanger side, because the FRPP "P" headers seem to like to eat the wires, but these ones are getting a tad worn out...Where can i get new ones these were on the car when i bought it.. Thanks
Top Bottom
Back
Forums
Menu