Search results

  1. Numbles

    CCW Wheels

    Anyone have pictures of any SN-95's with CCW classics. Ive searched and cant find. Dan.
  2. Numbles

    LS1 Notch Track Results.

    Finally took the mustang to the track. The car sat on some 245 nitto 555r street tires on both days. Car has a stone stock ls1/t-56 from a 99 camaro. Only thing done is a full exhaust. Car has a 3.27 gear. Day one. I got about 15 runs in so ill only post a couple. First run off of the...
  3. Numbles

    Heat doesn't turn off!!!

    After getting my car back on the road Ive noticed that the heat on my car really doesn't turn off. Even on the off position, the faster I go on speed the more hot air comes out of the vents. Anyone know what this could be. I went over all the vacuum lines and everything seems to be hooked up...
  4. Numbles

    Autometer Fuel Level Guage Hookup.

    I installed aftermarket guages in my car and the fuel level guage is reading completly off. The guage is at empty untill I get to about 3 gallons left in the tank. Then the more I drive the higher the guage reads. I checked the part #'s and it is the one that is for late model fords...
  5. Numbles

    Brake Switch

    Does anyone have a picture of a brake switch hooked up. When I took the pedals off of my car to switch them to the supercoupe pedals I had to take the brake switch off and now I dont remember how to get it back on. I dont see any possibel way to get it to work. I can get it to fit on the pedal...
  6. Numbles

    SN95 Fan Wiring

    Im in the prcess of wiring the elecric fan. I have the relay all setup but when I give it power the fan spins the wrong way. Anyone have a wiring diagram for a an95 electric fan. I have it wired and the ground on the center post and the positive on the bottom post. Anyone know how to get the...
  7. Numbles

    My LS1 Notch Project (DUW)

    I havent been active on the forums lately so I thought Id post a progress thread. Ill post up a list of all the mods soon but Ill show some pics of the buildup first. And please. I already know there is a bowtie in the car. :flag: No need for flaming. So here they are. First day of the...
  8. Numbles

    My LS1 Notch Project (DUW)

    I havent been active on the forums lately so I thought Id post a progress thread. I grew up in the 94-95 forums so I thought Id post here first. Ill post up a list of all the mods soon but Ill show some pics of the buildup first. And please. I already know there is a bowtie in the car. :flag...
  9. Numbles

    Wiring Harness Problem(Installing Fuel Pump Relay)

    I am no longer using the factory fuel injection harness on my 93 lx. The wiring harness hold the fuel pump relay so I need to install a relay. Anyone have a wiring schematic of the chassis wiring harness. My haynes manual has a few schematics however none label the fuel pump or wiring...
  10. Numbles

    Who kows how to HOTWIRE a car?

    My $200 car will not let me start it. Its a 93 mercury tracer. The key will go into the ignition but will not turn over. The ignition is frozen. We tried a breaker bar with a fladhead on the end and that wouldnt turn in over. Anyone kow how to hotwire it. I dont really care about tearing...
  11. Numbles

    Gauges

    Who has done a complete dash guage cluster from florida50 or something like that. Im going to get this myself but dont know which fuel level guage to get. They are measured in different types of ohm's and I dont know the range of the stock stuff. The car its going into is a 93 lx. Dan
  12. Numbles

    Fuel Pump Relay

    Anyone nkow where the fuel pump relay is on a 93 lx. I remember hearing it was under the passenger seat but that might have been in my sn95 days. Any help would be appreciated. BTW, there is non under my passenger seat so it has to be somewhere else. The only thing under there is the amp for the...
  13. Numbles

    Brake Proportioning Valve

    I just tried installing the FMS brake prop. valve in my 93 lx and the lines thread in but dont seal. Does anyone know the adapter fittings needed to get this to bolt up and seal properly. The valve doesn't use an inverted flare (?) wheras the stock lines do.
  14. Numbles

    Fuel Line Question

    What are the return and feed line sizes for a 93 fox car. I remember them being -6 for return and -8 for feed but cant remember. On summet I came up with a few but couldn't figure which ones I needed to connect to the factory hardlines. RUS-640870 -6 RUS-640880 -8 Would I need...
  15. Numbles

    Rear Main Seal Q?

    Im on my 3rd rear main seal on my turbo project. First one I did worked which was my first time ever doing one. When my trans case cracked I sent the car to my mechanic to change the RMS thinking that was it. So he changes the seal and finds the crack in the trans case. Anyways trans...
  16. Numbles

    Steering rack ? with 96+ spindles.

    After completing my 5-lug swap I did a quick home alignment to get the wheels straight. I noticed that with the extended wheel base I have with the 96+ spindles, my power steering rack is at the last few threads it seems right at the tie rod. Is there any other type of tie rods out there...
  17. Numbles

    Rearend brake line pics anyone?

    Im just finishing up my 5-lug swap and need a picture of the rear center brake line. They one that goes from the body to the rear end. Reason being, The braided one I got from discbrakesrus isn't like the factory one. It comes with the distribution block for the rearend hard lines on one...
  18. Numbles

    Lower control arm Bolts?

    Anyone know where to get front lower control arm bolts. In the process of changing the front suspension I found that the right side bolts were rusted to the bushing sleeve. And I cant find anyone thats sells these bolts. Because I need to source them before I take out the sawzaw and cut the...
  19. Numbles

    Who here autox's.

    Im changing my combination for a more cornering able type car. And have a few questions about how others have setup their suspension. Ive always wanted to get strange ajustables because my goals have always been set on drag racing. But I dont know if they are a good idea for cornering...
  20. Numbles

    Bellhousings. Steel or get another aluminum one. TKO.

    Im in the middle of my turbo build and I have to get a new bellhousing. My aluminum one for my tko has cracked. The 3 Im looking at are Aluminum $179 Lakewood $399 Mcleod $299 Is it worth the extra money. I dont plan on putting out any more than 500rwhp. For now anyways...
Top Bottom
Back
Forums
Menu