Search results

  1. spdfrkaby

    Thinking about selling Mustang.....opinions on why I should or shouldn't

    Well I'm pissed off at the damn car now. Installed the ProCharger no problem. 1 1/2 months later I blow a header gasket on the driver side. Have a buddy fix it and find out that 3 of the 8 threads are completely stripped and it looked like it already had helicoils on them. (longtubes were...
  2. spdfrkaby

    Question on aftermarket header gaskets???

    Well I put the supercharger on about a month ago and now for someone unknown reason maybe extra airflow the driverside BBK long-tube header gasket is leaking and the car sounds like crap. I was quoted $550 just in labor to change out the gaskets. I did some research and see that a lot of...
  3. spdfrkaby

    Would 03 Explorer 31 trac loc and 3.73 directly bolt into 00 GT

    I found a rear end from a 2003 Ford explorer that says it comes with a 31 spline trac lock carrier w/ABS reluctor/Exciter and the stock 3.73 gears with 10K miles on it. Question is will this directly bolt on into my 2000 Mustang GT and what else would I need. I'm not too familiar with this...
  4. spdfrkaby

    Question on mid pipe with supercharger

    Just got car dyno'd with P1SC. I have BBK full length headers, stock h-pipe and 2 chamber flowmasters. Question is, I need to upgrade my stock h-pipe for a BBK aftermarket mid pipe. Will an x-pipe or h-pipe give me more gains and should I get one with hi flow cats or no cats if emissions is...
  5. spdfrkaby

    installed aviator fuel pump. have question about pump filter though.

    Alright, I got the Aviator fuel pump installed and running. I have a question though. I used the stock bucket and float, just changed out the fuel pump. The aviator pump had a huge filter/sock I don't know what you call it attached to the bottom of the pump. I tried and tried to get the pump...
  6. spdfrkaby

    Opinions on F1 Racing Stage II clutch

    Well I was searching on Ebay for clutches and flywheels and came across a F1 Racing Stage II clutch and a Fidanza aluminum flywheel for $475/both. I know the Fidanza is a good flywheel but I never heard of F1. Did a search and nothing came up. The ad says it holds up to 460hp. Does anyone...
  7. spdfrkaby

    Best chip to get mailorder burned without a dyno for supercharger.

    Car is pretty much finished with the ProCharger install. Just need to drop the tank to put in the Aviator pump. Question is what chip should I get that I could get burned and sent to me through the mail. I'm in North Dakota where I will be unable to get a dyno tune so it will have to be...
  8. spdfrkaby

    Need opinions on 31 spline axles, and trac lok....

    I'm in the process on installing a ProCharger P1SC on my 2000 GT. Please no bashing ProCharger on here just need help on the rear end. Had a question as too which trac lok would be work at a decent price. Searched on Ebay and found a Ford Racing Trac Loc 31 spline for $225, I think that's...
  9. spdfrkaby

    AHH, my BBS 18's are peeling, what happened??

    Hey peeps, what's going on here? The car hasn't been up for a winter yet so I know it's not from the weather and there isn't any salt laid down here so anyone know what's going on here. I just walked out of a store thought it had tar on it but it was the actual rim. The previous owner, which I...
  10. spdfrkaby

    AHH, my BBS 18's are peeling, what happened??

    Hey peeps, what's going on here? The car hasn't been up for a winter yet so I know it's not from the weather and there isn't any salt laid down here so anyone know what's going on here. I just walked out of a store thought it had tar on it but it was the actual rim. The previous owner, which...
  11. spdfrkaby

    In San Antonio for 2 wks, need shop for P1SC, dyno, 3.73, clutch install.

    How's it going guys. I'm headed over to San Antonio for some training for two weeks and I'm trying to find out if anyone knows of a good place that could hook all of this up for me? I was going to go to MP in Atlanta but ran out of time to get it over there. I'm headed back up to North Dakota...
  12. spdfrkaby

    need belt for ProCharger P1SC

    Was wondering if anyone knew if there is a replacement belt that I could pick up at any parts store. It's for a 2000 Mustang GT P1SC. Thanks in advance.
  13. spdfrkaby

    Tranny grinds sometimes during downshift...clutch or tranny???

    This has been a problem for quite some while but didn't think too much of it since it wasn't that major, it's just an annoyance now. Only thing aftermarket dealing with the tranny is a short throw shifter. Stock clutch and flywheel. When I'm downshifting through the gears mainly from 3rd to...
  14. spdfrkaby

    Which stage Mcleod for ProCharger and future shortblock???

    Ok now that I've decided on what and where to buy the clutch and flywheel, I have another question. I will be putting a ProCharger in which will be pushing about 400hp then in about a year I will be doing the shortblock (around 500-550hp). Question is which stage clutch 1-4 should I get and does...
  15. spdfrkaby

    Best place to order McLeod clutch and Fidanza aluminum flywheel?

    Been doing some research on the best setup since I'm about to install the ProCharger. Figured out what I wanted but now I need to know where the best price for these are at. Thanks in advance and if anyone has any other better options/combo's I'll take that too.
  16. spdfrkaby

    nice little mod I thought I'd share. (LED license light)

    Hey guys and gals. Just thought I'd share I nice little apperance mod I did to the stang not too long ago. Haven't heard or seen anyone do this yet but I feel a lot of you all will think about it since it's so much cleaner. Basically replaced the stockers with two 4 LED housings from custom...
  17. spdfrkaby

    Clicking noise coming from front wheel when moving

    I've been trying to narrow this down for the last two days and haven't been able to figure it out. Yesterday there was only a clicking noise on right turns and today it clicks constantly. I put it up on a lift yesterday and rotated the wheels and it didn't click so this only happens when under...
  18. spdfrkaby

    need help on rough idle. changed iac to no avail.

    So I did all the main problem checks: cleaned the air filter and put a new IAC on and it still rough idles and dies sometimes idling or when the clutch is engaged. Does anyone have any idea on what else it may be? It has a BBK cold air with BBK filter and BBK 70mm throttle body along with BBK...
  19. spdfrkaby

    ???Changing rear end for supercharger???

    Again, somewhere on the vehicle I don't know too much about. From research I know I should upgrade to 31 spline's and either strange or moser are about the best. The thing I don't know is about the eaton or auburn t-loc's. Is this part to lock both tires up at the same time for drag...
  20. spdfrkaby

    supercharged engine???rotating assembly or shortblock

    Hey everyone, don't know too much about the lower end. I have a ProCharger P1SC and was wondering if I would be able to just change out the lower end with a forged crankshaft, upgraded pistons and upgraded h-beam rods. Would that be enough to make 500-550 hp or would I need to upgrade the...
Top Bottom
Back
Forums
Menu