Search results

  1. airbag

    injector conversion

    i have a set of 03 cobra injectors 39lb. is there a wiring conversion to install these into a 1992 fox body stock harness? i got these by converting an 03 cobra to fox injector style 60's. just havent found a conversion the other way. i have searched. i understand i have to recalibrate my mass...
  2. airbag

    What is this?

    This is located behind the passanger strut tower. can i delete these to clean up the engine bay, or do i need these. this is on a non-emission car. thanks nate
  3. airbag

    alt charging

    i have installed a new 1 wire promaster alt., new battery, ran new grounds from the front and back of alt. to the battery, body to chassis ground strap is good battery to chasis is good. car goes from 12.5 not running to 12.6 right away and slowly charges after driving for about 10 min will...
  4. airbag

    alternator wiring

    alt not charging on car in sig brand new alt. has been tested all wires on the alt connectors have 12v with key turned on except white wire that jumps from connector to connector. with car running white jumper shows 6v all wires on alt connector check good on continuity. alt. grounding...
  5. airbag

    btm timing

    with the mods in my sig what should my timing be set at, and what should btm dial be set at it has a setting from 1-3 degrees. i am running a fmu. thanks nate.
  6. airbag

    cobra mass air meter

    will a 2003 cobra mass air meter work in a fox, with the correct plug wired in.
  7. airbag

    30lb

    does anyone have dyno proven results that say 30lb inj will or wont work on my sig with no fmu.
  8. airbag

    fmu

    at what point do i need a fmu? combo is in sig, with the addition of a paxton sn92 8lbs. of boost and 30lb inj.
  9. airbag

    bad egr?

    is it possibe a bad egr would effect idle learn. i have check all vacuum connections and gasket mating surfaces for a vacuum leak car doesnt seem to idle learn 100%. changed intake and had to slightly modify the shape of egr to clear afpr. knowledgable info will be greatly appreciated.
  10. airbag

    30 lb injectors

    i get a lot of different opinions. are these inj. too big, i have 30 lb. inj. with pro m meter calib. eddy 202 160's ,1.6 rr, cobra intake, 70 mm tb, x cam, dss shortblock, flows dumped, 255 pump. would i gain by going to 24lb inj, meter? does anyone else use x cam? dss recommended this cam (not...
  11. airbag

    dyno results

    went to the dyno today. it was a dynojet, and my results were 259 hp and 290 tq. mods are in my sig. what do you guys think? motor is completely fresh. the guy had 8 other fox body mustangs results posted and all were within 10 hp ?
  12. airbag

    stock springs?

    will the stock 2000 gt coil springs work in a 92 gt, and still be the same height? thanks.
  13. airbag

    alternator swap

    is it possible to use a 2003 alternator on a 1992 5 litre set up. looking for more amps. already have alt. thanxs
  14. airbag

    pedestal vs. stud mount

    i have a set of aluminum eddies rpm older style with 2.02's and a 5/16 hole for pedestal mount rockers, but already own a set of 7/16 comp cams 1.6 stud mounts. research tells me i can convert my heads to stud mount rockers for $90.00. should i convert or sell my rockers and buy a set of...
  15. airbag

    clutch?

    looking for a clutch for the car in my sig. any suggestions? has anyone ever had a car tuned by anderson motorsports? prices? in the chicagoland area looking for a good tune.
  16. airbag

    coba intake

    cobra intake the car is a 92 gt dss 306 shortblock fully balanced, x cam, 1.6rr, edelbrock 2.02's, have a cobra intake, do i need something bigger or will this work.
  17. airbag

    331 combo

    92 gt 331 dss rotating assembly, stock block, iron gt 40 (ported), cobra intake, e cam, 1.7rr, stock tb stock inj. think this tb and inj. can keep up? do i need better heads? or should i go with a 306 rotating assembly, need suggestions. thanx
  18. airbag

    connecting rods?

    i am on a budget got a price on reconditioning stock rods ($96.00). found some new eagle stage 1 rods on ebay $203.00. does anyone run these or know of anyone? or should i just recondition my old stock rods
  19. airbag

    performers or vic jr.

    my car consists of 89 notch stock bottom end 302 edlebrock alluminum 190 valves, 58cc,1.7 rr, e303, trickflow street intake,sn93 paxton 6psi,btm,70mmtb,mass air meter. a buddy wants to trade me heads mine for a ported set of vic jr. w/202 valves not sure of cc.are these a good trade, or too...
  20. airbag

    gt40's f303

    i have a 92 gt stock bottom end 302 cobra intake,gt40 heads ported 1.6 roller rockers after market springs lookin to put in a f303 cam will i come into a problem with piston to valve clearence. or should i look for a different cam (any suggestions). all advice will be greatly appreciated.
Top Bottom
Back
Forums
Menu