Search results

So I installed a Team Z K member and finished up the rest of my suspension stuff this weekend on my '89. However for some reason I have hardly no threads on my rack going into my outter tie rod end on the drivers side. There's probably an inch or so threaded into the tie rod end. The passenger...

Does anyone know where I can buy a video of how to rebuild a Tremec 3550? Hanlon Motorsports doesn't have any and they dont know when they are going to get more of them. I have a video from them on how to rebuild a T5 but I have been told there are some differences between parts on the two of...

Can you take a A9L from a foxbody and use it in a SN95? Also vise a versa can you take a speed brain computer for a 94-95 and use it in a 89 foxbody? Any help on this would be appreciated.

O.K. guys. I drove my car all day Monday and parked it. I pull it out of the driveway Tuesday morning and go to take off and I have this horrendous vibration at 3000 RPM's and it starts to feel like its not as bad after 4000 RPMs. So here's the real kicker to this. If you are sitting still in...

O.K. so today I decided to to move 4 hot wires which are for my nitrous stuff from the positive post of the battery to the one side of the solinoid where everything else is. I then took 2 ground wires off my negative post of the battery and grounded those to the chasis. I go to start the car and...

Why is my car loading up on the bottom end? If I am following cars in traffic and just holding staedy at low RPMs say either in 2nd or 3rd gear and I get a little bit of a clearing to speed up as soon as I go to accelerate the car acts like it loaded up and then you will get a backfire or 2 that...

I just picked up a set of Aluminum GT40Y heads and I am going to put them on and take off my GT40 P heads. Will these heads flow better than the 40P's? Will I be able to tell a difference or is this going to make the car a pooch. With the 40p's on there the car pulls super hard from idle thru...

O.k. right now I have a F cam that everyone and their brother tells me that it is slowing me down when I run naturally aspirated. When I spray the car it it great. So with that being said Comp Cams claims they have a cam that has the same max lift as the F cam which is .512 on both intake and...

If you look in my signature you will see my current set up that I have right now. Would I benefit to go to a early 70's 351W bored 0.40 over short block and throw all my stuff on there from my current 302 set up or will I lose power and torque and be wasting my time? I need some advise on this...

Is the fuel injector harness for a 1990 the same as the fuel injector harness for a 1989?

O.K. guys I need some help here. I put a set of GT40P's on my car back in Sept. I noticed that the car started to have some cooling issues after that. I have a autogauge Temp gauge that is mechanical and the needle would go all the way up to 220 or so and then go right back down to 140 or so...

O.K. I need some help here guys. My car keeps surging and wanting to stall out when I stop or push the clutch in. I just replaced the TPS in it and that did nothing. I pulled my IAC off and low and behold its clean as a whistle. I hosed down my motor and vacum lines with Throttle body cleaner...

Anyone have any idea of how much a set of E7 heads with new seals are worth.

I am currently running 4 cyl springs in the front and rear. I have been considering going to a coilovers up front with strange 10 way adjustables. A friend of mine has a set of strange 12-170 springs that I was going to purchase. My 60's N/A right now on D/R's are 1.79 - 1.83. I plan to run on...

I picked up a Air to Fuel Ratio guage today. The one wire on the guage needs to hook to the O2 sensor signal wire coming off the computer. Does anyone know what color I am looking for here or what pin #?

O.K. so I beleive I may have a blown head gasket. For about a week now or so my coolant has been overflowing on me and sometimes its fine and sometimes its not. The car will heat up real quick and if I drive it it will shoot up to 210 -220 or so and then I pull off the radiator cap let it...

O.K. my cooling system is all messed up and I can't figure it out. I replaced the thermostat and still no good results. Last weekened I had my to heater hoses diconnected from the firewall so I could get to my pressure regulator to change it out. Now I hooked the hoses back up and everyday I...

I run 14 degrees timing N/A. I am going to run a 100 shot and I am trying to find out if I am safe to run it at 14 degrees initial or not. I have been told yes and I have been told no. Not sure what to do. I perfer to run it at 14 degrees but I perfer not to screw anything up also. The car runs...

For a week now my car has been backfiring thru the exhaust and the intake anytime you put it under a load whether its a light load or heavy load once you reach 4000 RPM's and higher. It only seems to do this from 3rd gear on up. Every once in a while it will do it in 2nd but very seldom. The...

O.k. guys last week I took the car out for a drive and got on the hywy and as soon as I got into 3rd gear and got up to 5000 RPMs the car started bucking and missing so I got out of it. I had the control module checked out and it was bad so I replaced it. The plug wires are only about a month...