Search results

Very good condition set of 16" Pony wheels with 95% front tires and about 50% Nitto DR's on the rear. Located just South of Louisville Kentucky. I can meet in a reasonable distance if the price is right. Let me know if you have any questions. $400 OBO Thanks...

I just put a new top on my car and I have begun installing the weather stripping for the top and pillards. Has anyone had any problem with the 50resto stuff not fitting right in the grooves. It seems that it is to small. Did anyone use a glue of sometype? Thanks for the input!

After I run my 89 a small amount of coolant will leak out from a hole under the heater core connections. I see it coming out and its about 9 inches or so below the heat core connection. What would this be? Is it some type of over flow. I know I don't have to much coolant. It only leaks about...

Ok, Ive searched all over on here and on ebay and I can't find the big 30 page or so instructions for a convertible top install. Could anyone lead me in the right place. Thank you, Ed [email protected]

I have done some research and I can not find a clear anwser. I am swapping to a manual from an AOD in my 1989. The T5 has a back up light wire and another plug... what does this plug do? There is only one plug under the car which is the backup. Thanks Edward

On the red interior GT's (1989) with the two tone dashes, is it black or is it a Charcoal Gray color. I am looking to accent that color with door panel carpet. I can not tell if mines faded or if its not black. Thanks!

Ok, I'm near completion of my "first" re-build. (302, heads, cam, Roller Rockers, ETC). When you all re-assembled your engines did you leave off the valve covers (not sealing them) until you had the engine in the car and running. Or did you seal them before. Reasoning for the question I'm...

Ok this is one of those moments where I might be over anyalizing. I bought a 302 with stock E7 heads. I had the heads ported and went to re-install them. Are heads directional? I'm not running the smog equipment so then does it matter if the ports are on the front or the back? It will...