Search results

Doing the conversion on my lightning and trying to get my ducks in a row before i order parts. Does anyone know the size of the pinion shaft coming of the stock rack and pinion of a 2005 mustang? I can't find any info on the stock one, just the flaming river manual rack which says theirs is...

I've got a miss in the #1 cylinder. I first pulled the plug and it looked very clean with a very slight brown hue, but the electrode was so clean it looked like it had just been pulled out of the box. The plug looked a little wet after the car had been ran so i figured the injector may be stuck...

what is the best manual brake conversion kit for the money? I've seen how the maximum motorsports kit comes with the new pedal and linkage etc.. but is all that stuff really necessary?? this is going to be a drag only car. Can i just use somethinng like the upr manual master cylinder?

anybody remove the metal support in the dash?? i know there are some mounting points there but i was thinking i could cut out some of the piece where there are no mounting points to lighten is up a bit. just seems a little heavy for a dash to me. going to be a drag only car so if the...

I'm getting ready to do the rear suspension in my hatch, and i just wanted some opinions. i want to keep it as close to stock suspension if i can (i'm not sure if coil overs change that) the car will be getting a 460 bb and eventually a decent shot of spray. I was looking at the extreme...

http://www.stangnet.com/mustang-forums/804490-urgent-need-help-cant-get-bellhousing-bolt-out-tranny.html#post8101257

We are working on a 2001 cobra, and we are trying to get the last bolt out of the bellhousing. It it the very top bolt on the driver's side. Are there any tricks to this. we have tried different sockets and swivels and extensions moving the tranny up and down to get different angles etc...

i want to put a k-member in my fox and i was looking at upr and maximum motorsporsts stuff. I would like to do a kit but the prics difference between upr and mm is huge. i know the mm comes with the caster camper plates, adjustable tie rods link, and all the swaybay stuff but why such a huge...

Just had a couple questions for you guys that have swapped cams. A friend asked me and a buddy how much to charge him to swap cams and springs in his 05 gt. I've done cams in a Lightning before but not in a mustang so im just wondering what the average time frame is to do this in as well as how...

i'm starting to gather some info and putting together a parts list to start my build. what is needed to put a big block in a foxbody? its a 93 hatch and i'm planning on putting a tubular k-member in it (not sure on what brand though). Just wondering if there is a specific k-member that i...

I have stock 302 at the moment and i want to build the bottom end while i have it out of the car. I would like to make it a stroker and I have been looking at a lot rotating assemblies. I would like to stroke it to a 331 using a forged crank with a 3.25 lift and a forged rods as well with 5.4...

the a/c is deleted in the hatch that i just picked up. I've got the motor out and am going over everything but i was wondering if there is a delete pully that i need when the a/c is deleted or can i just route the belt differently?

What is the best quality and easiest to install driveshaft loop for my 93 hatch?

i don't know if i'm blind, but i didn't see and intro section so i'll just do it here, my name is matt and i live in S.W. Florida, I just bought a 93 fox body with a carbed 302 and 10 point cage. The previous owner was plannin to turn it into a drag car but lost interest so i'm going to pick up...