Search results

I am going with Mac longtube headers and a Prochamber from Mac but the prochamber I believe was used on an Auto and am wondering if it will fit in my 5-speed? I'm not really sure whta the diference is between auto and manual h-pipe's when going with longtube headers.

I have searched but not found an answer does anyone know if the MAC prochamber for Longtubes has a 3 bolt pattern to match the lontubes collector 3 bolt pattern? I know the shorty headers have a two bolt pattern. Thanks in advance.

I'm haveing trouble when my car is running with the A/C on sometimes when I'm downshifting the RPM's go way down with the volts and sometimes it dies so I pulled these codes off the car today. Battery and Alternator are new so can you read these. 34,67,10,11 All these came off the car but I...

When I'm in gear and push the clutch in when I'm coming to a stop somtimes my RPM's will come way down below idle and sometimes it even dies. What causes this or what can I change to fix this problem? It does it mostly when the A/C is on. I have no mods to the motor, no pulley's, etc...

What can be done to get moisture out of my aftermarket healight? I was told to drill two very small holes in the bottom corners of the lights and that this would prevent it, anyone hear this?

has anyone gutted the stock h-pipe on the stangs? Is there a lot of difference to be expected? I did this on my 96 cobra and it made it a lot louder at WOT, I want to have the look of cats because I have had a few state troopers actually look under my old car to see if it had cats on it...

Does anyone have the Exploded drawing of the door hinges and the pins and where exactly the bushings go? I replaced mine and the bushing on the lower hinge keeps hicking up and out of the hole, all I have to do is tap it into place but its a pain, I tried to put a little JB weld on the bushing...

HELP ME STANGNET !ok Someone help please, problems with A/C and heater fan!!?? I have a 93 LX 5.0 and my A/C will blow cold, my heater blow hot, it will also change speeds from hi to low no problem, but no matter what I put it on (defrost, A/C, floor, Vents, Mix) it will only blow out of the...

I know for longtubes you have to jack the motor up, but do you have to jack it up for the shorties? Also is it better to have the equal or unequal shorties? Explainations would be great for the reasons why, and why do you have to jack up the motor?

OK this may be a stupid question but I gotta ask. Can you change the pulley on the A-Trim blower to say about 8-9lbs.? My car (93 LX 5.0) has 147K on the original motor, all stock now so I don't think I need an S-Trim now, just a little bit more power until I rebuild the powerplant which will...

OK, how hard is it to put the gauges in the AC vents (93 LX) with the cage from Autometer? Do you have to go into the dash to get the lines through the AC hoses that go to the dash to hook up the gauges? I'm trying to find out what all is required from this install, thanks!

Whats the deal with cats on the MAC Prochamber, do they not need them, or is it for "off road use only?" Will it pass emissions? Thanks

I am trying to find out how thw 1 chamber flows sound, I got spintechs now but want something louder, can someone tell me the sound clip website, I can't remember what it is. Thanks