Search results

thanks hissin for the reply, this setup is actually in a 78 f100. i used the telorvek panel and wiring from the detail zone for the installation.the 4.6v i was getting was on the wrong side of the sensor.yesterday i put it on the other side and at 5.2v the low speed came on.the guy at the detail...

i have a 95 mustang 5.0 with a W4HO pcm & aode. the fans will not come on at operating temperature.ok,this is what i have done so far.applied 12v to the #14 wire and the low speed comes on.i then applied ground to the #17 of the ccrm and the high speed runs.i can turn the a/c on and the high...

i am going to try and use the shaker setup.as for the interior i am going to pick it up tomorrow and i will post some pics......thanks roger

i was told the front clip is worth 3k alone.make me an offer...

actually thats the reason i bought the mach 1, its an automatic...........................................thanks for the offer

i just purchased an 04 mach 1 hit in the rear.i need the motor and tranny.would anyone on here be interested in the rest of the car? or maybe tell me what the rest of the car is worth.

that would be a t-10 borg warner.

thanks guys for the help along the way.now its time to move on to the next project.please see ebay 230055157127.........................thanks

i have a year one bezel w/phantom guages ended up with 600.00 in the setup including wiring and plug for the harness.if you go with the manual speedo make sure to get an adapter.the speedo uses the older screw on type cable and yours is probably a snap on type.or you could use a 68 and down...

thanks....it was alot of hard work but worth it.

no,you dont have to sand in between.i usually start with a light tack coat then get a little heavier each time (15 min or so in between). be careful not to run.

its very easy. i would just start with a small piece first. i usually put on 3 coats and after you see the results you will want to do more.

i have not had much luck with aerosol clear.first drop of any chemical and its ruined.auto clear does a much better job and it is easy to clean.

i sprayed mine with cast coat aluminum and then sprayed them with automotive clear with a touch up gun.i could not beleave how they came out.so i did the brake calipers,brackets,hood hinges,control arms etc.everyone swears i had them powdered coated.www.cardomain.com/ride/2073886.

that looks like a 17 x 9.5 !

that is correct.jack up the car placing the jack stands under the rearend housing and let all the weight down on the stands. this will be correct ride height.mount the sway bar to the springs first then swing the sway bar up to the frame rails,mark holes and drill. ubolts will then slide in one...

anyone!

does the trans control switch module (1995 mustang aode ) serve any other purpose than to switch it in and out of od? it just doesnt seem to shift correctly plugged in.

i have the setup on my 69 but i have a streetrod type booster.hope this helps.www.cardomain.com/ride/2073886.

i feel your pain! i went through the same thing.i tried to bend the tubes and it was still at a bad angle.you have 2 options, shortie headers or hydraulic setup. i went with the shortie header just to find out later that the cable setup wasnt that great.it seemed to be fine to start with but...