Search results

  1. P

    Picking some brains.....

    I have 2 different mustangs that I have questions on... first is a 2000 auto. I’ve replaced the harmonic balancer and yet it still has a horrid vibration.... of the engine mounts are not centered in the k member can this cause my issue? I noticed the last time I was under the car that the...
  2. P

    No electrical power

    Terminal stud on the dis box does wiggle a little but does not spin as in not broken.......... battery was fully charged (came off of my GT)...... no breaks or cracks in the engine to body ground....... I have a spare battery harness laying around that is unbroken and has no cracks, should this...
  3. P

    No electrical power

    I have no power at all. Tried googling and all I can come up with is the CCRM. Dont really want to throw money at it by way of a shop but I have quiet a few parts laying around. Could the CCRM being fried cause my no power issue?
  4. P

    03 over heating

    The CCRM's were from a pick a part so not that bad. That was part of the issue as after the second one, the fan was trying to kick on. Radiator is not obstructed and is clean and free flowing. Fan was a new one. Bleeding the cooling system- that I was unfamiliar with but have since gotten that...
  5. P

    No electrical power

    Couple years ago I purchased a COpart auction car from an individual for a 5 spd swap. Car is a 2000 v6. Ended up not pulling the trans and now I'm trying to get the car running. My issues arise when I put a hot battery on the car and no power is getting past the distribution box under hood to...
  6. P

    03 over heating

    The only thing I haven’t done yet is replace the thermostat. My sons 03 v6 auto started dec 18 overheating when he got stuck in traffic. Replaced the fan, radiator, temp sensor, flushed the system, replaced the whole engine ( long story their) and 2 CCRM. When he gets stuck in traffic his car...
  7. P

    03 gt auto speedometer acting wonky

    I recently picked up an 03 gt auto that is now giving me issues. My speedometer will set fine at speed for a little bit and even the cruise works great until the needle starts jumping. By jumping I mean it’ll peg out at 150 if I’m going 70 and cut cruise off. I’ve narrowed it down to the vss but...
  8. P

    2000 GT wiper issue... PLEASE HELP

    Ok...I don't have access to a volt meter but.... I do have an 03 parts car that is a v6..... are the GEM the same across the board? Or are they great and vehicle specific?
  9. P

    2000 GT wiper issue... PLEASE HELP

    Ok recently I purchased my son a 2000 gt. It was built w there mach 460 sound system but whenwe picked it up, it didn't have the rear amp or speakers nor did it have a radio. Actually the factory plugs are cut. Also the wipers and squirters do not work. I've replaced the multi function switch...
  10. P

    S197 seats in to a SN95 New Edge

    Has anyone put both front and rear seats from a S197 into a New edge? If so what is needed to get the rear seats to fit? Also if you have done this swap post up some pics please and thank you. Nate
  11. P

    Has No Power

    Ok so I've finally gotten my son's 00 out bask together and on the first drive... it had some decent power. Fast forward a week when I took it out again... the car had no power and would not pull a small hill. No...i have not put a tinder on it. Yes I have deleted the egr. Yes I have deleted all...
  12. P

    What An I Doing Wrong.....

    working on a 00 v6 auto. Just got through replacing the engine and trans.... engine was from a 00 v6 w 100k miles and trans wss from an 03 with about 120k miles. engine is running great but when I put it into gear it dies. What could it possibly be causing this? Thanks Nate
  13. P

    Help Please... No Spark

    Ok so I finally got the engine buttoned back up with all connections and hoses in place. Btw I'm working on a 00 v6 auto. Made sure I have fuel pressure but I have no spark. I've tried 2 different coil packs. I don't have a volt meter to check but I have checked all grounds. Engine cane out of a...
  14. P

    Ok So This Is A New One On Me

    While working on my sons 2000 v6. (Had the e ginger and trans out of the car) I pulled the trans pan off to change the gasket and filter..... to my surprise there was a little yellow plastic plunger looking thing just laying there in the bottom of the pan. Does anyone know what the heck it is...
  15. P

    Help With Engine Swap.

    So the oil pump went out on my sons '00 v6... not that big of a deal right... unless he doesn't pay attention and it ends up throwing a rod out through the bottom of the oil pan. Now to my question. I have an '03 v6 donor that I didn't realize had a few extra parts on the engine. As far as he...
  16. P

    Rear Quarter Panel

    Just curious as where/ if I can get a replacement outer wheel arch quarter skin? OR do you have to replace the entire quarter panel? Someone backed into my son without insurance in a parking lot and now I am stuck with the repair bill. Local body shops are wanting between 2k and 3500 for the...
  17. P

    Core Support

    who all has had to have their core support replaced? My son's 00 v6 is needing one and all the body shops around here are quoting like 1k to 1500 for replacing it. According to the estimates they are ordering one that costs between 600 and 650 for it. The rest is in labor and paint. Btw I'm in...
  18. P

    ? Stroked And Blown?

    cost wise compared to output, is it worth it to stroke out our 3.8's with the 4.2 stroker kit and aside from the programmer, if I have access to a 3.8 supercoupe engine and harness what would I need to put it in my 00? I'm just asking before I start spending money on this project instead of a...
  19. P

    Winstar Intake

    Just curious, Is there any power gain to doing this? or is it just for aesthetics?
  20. P

    Wiring Probs

    Recently the speedometer in my 95 GT Vert stopped as well as the interior lights and dash clock. thinking that the top was leaking and causing the #4 and #8 fuses to blow as soon as they made contact, I pulled the dash and went through the entire dash harness checking every wire and then...
Top Bottom
Back
Forums
Menu