Search results

I have a set of Pro Topline aluminum heads and a set of roller rocker arms for sale. They heads have 2.08 in. Intake valves and 1.80 in. Exhaust valves. They have around 1,000 miles on them and were used on a 1990 Mustang 5.0, I believe they will work on any pre-95 Ford 302 and 351W?. I am...

I have a set of Pro Topline aluminum heads and a set of roller rocker arms for sale. They heads have 2.08 in. Intake valves and 1.80 in. Exhaust valves. They have around 1,000 miles on them and were used on a 1990 Mustang 5.0, I believe they will work on any pre-95 Ford 302 and 351W?. I am...

I have a 95 GT, and my power steering takes 2 hands to turn the wheel, its not as bad as with the key off but it is not nearly as easy as it used to be. I have replaced the ps pump twice, the rack, flushed the lines, replaced the fluid, checked to make sure the lines were in the correct...

Hello everyone, My boss has a streetrod setup to run a 5.0, but has decided he would rather run a 4.6L. That brought up these questions that I know you guys can answer, I only know 5.0's and am not that familiar with the 4.6L. Are the bellhousings the same? Are the motor mount...

My headlights are very weak and i can hardly see at night, what did you guys do to get better lights, will just a bulb swap help? Thanks BTW if so what kind should i get

Heres what I ran 60' 2.23 330 6.164 1/8 is 9.48 mph 75 1000 12.245 1/4 14.731 mph 93.4 I had a hard time launching cause i was driving my auto camaro too and was having to jump back and forth, I think i had alot better launch in me well see next week, this is with the mods are full...

My buddy has a 99 cobra vert, with exhaust and only exhaust, I know he should eat my 95 gts with full exhaust up, but where will i need to run down the 1/4 to have a chance (both are 5 speed cars and i am a better driver). BTW I have a built camaro ill try him in if its too much to beat him in...

Timing/Temp pulling my hair out please help???? OK heres the deal, I just but my 95 5.0 about a month ago. i just put a full exhaust on it this weekend and decided that it felt a little sluggish so i decided to check the timing, I pulled the spout out, fired it up and checked it, it was...

My question is what would cause just the two lower settings of my heater fan not to work, while the upper two do??? I'm confused is there a seperate relay for these, maybe a fuse?? Any help is appreciated, thanks Russell