Search results

Thanks.

I bought a new heater blower motor switch resistor (pic 0900) for my new heater box. No fasteners were provided to secure it to the box. I have the old ones, but they're not in good shape. Where might I buy some new ones? http://members.cox.net/steel3rivers/IMAG0900.jpg (top of photo).

Ok. Thanks.

When do you use tape on threads? What about the heater hose fittings into water pump (pic 554) & into intake manifold (pic 559)? ... the vacumm line into distributor (pic 411) and into carb (pic 921)? ... the vacuum modulator line into the intake manifold (pic 922)...

I was replacing the heater core & hoses when I noticed a crack in the heater box collar. What is the best way to fix it? ... glue or something else? http://members.cox.net/steel3rivers/IMAG0860.jpg What is the best way to clean the foam and rust from the inside surfaces... before I use...

Any suggestions on where to look?

I bought a remanufactured carb (Autoline, C806A) to replace the Holley 1940 (tried rebuilding, but I broke the main well tube). Photos are at: Pictures by steel3rivers - Photobucket Photo 'DSCN3092' (old carb, Holley 1940) shows the Spark Control Valve screwed in (left side). (Other...

I grounded the sending unit wire and the gauge went to full. When the SUW was not grounded, the gauge remained at empty. After I reconnected the SUW to the tank, the gauge went from Empty to 1/4 full. I know the tank is about 3/4 full... so that reading is not accurate. So the problem is the...

The temp gauge works.

My speedometer is not accurate. It hasn't been for a while. My guess is that it's about 10-15 MPH below the true speed. Any ideas how to fix? I don't know if this matters but the transmission was rebuilt in '97. Thanks,Tom.

The fuel gauge is not working. It was working fine until the body restoration, but hasn't worked since. Any ideas how to fix?