5.0 in a 94 V6?

Discussion in '94-04 V6 Mustang' started by thorguy57, Jan 18, 2004.

  1. thorguy57 New Member

    Member Since:
    Nov 27, 2003
    Message Count:
    2
    Likes Received:
    0
    Trophy Points:
    0
    Can anyone tell me what I would need to put an engine out of a 94 or 95 gt in my V6 auto? I know the engine, computer and wiring harness but will my tranny bolt up to it? Do I need different motor mounts or fuel system? If someone can tell me what I need it will be very much appreciated. Thanks. Also does anyone know where I can get a removable hardtop? Thanks
    thorguy57, Jan 18, 2004
    #1

  2. dastang2 Active Member

    Member Since:
    Dec 12, 2003
    Message Count:
    2,058
    Likes Received:
    0
    Trophy Points:
    46
    Location:
    tx
    what tranny do you have the 5 speed needs to be upgraded to a t5 it is strong enough for the v8. springs in the front need to be upgraded.radiator and stuff.
    dastang2, Jan 18, 2004
    #2

  3. thorguy57 New Member

    Member Since:
    Nov 27, 2003
    Message Count:
    2
    Likes Received:
    0
    Trophy Points:
    0
    its the auto
    thorguy57, Jan 18, 2004
    #3

  4. dastang2 Active Member

    Member Since:
    Dec 12, 2003
    Message Count:
    2,058
    Likes Received:
    0
    Trophy Points:
    46
    Location:
    tx
    you may still want to check it out to see if it is strong enough behind the 8. you could make this beast carbed and go around the hassle of rewiring stuff. if i had a t5 tranny i would put my built 302 in there and have it carbed. my motor is out now so it would be nice. but i just have the v6 5 spd. tranny
    dastang2, Jan 18, 2004
    #4

Share This Page