67 Rocker moldings

[mozpony]

I,m installing new rocker moldings on a 67 . The car is newly painted so i have no holes to rivet the molding clips to . Can someone give me a little direction on placement and spacing?

 

[denisd]

I believe mine are in the original location because the car hasn't been restored to that point. I just measured them and their are 4 flat head screws. 3\4" from each end are 2 and then measure in 11 3\4 inches in from them. They are 5\8" in from the outside edge standing outside of the car. There are none in the middle as this would go through the Ford emblem. Should have mentioned mine is a 67 coupe


Hope this helps Denis

 

[Jester67]

If you still need it I have the drivers side molding off my car and can get you pic's and dims. Just let me know