Lol there was Sam Adams and Blue Moon to wash it all down. (If I was buying the beer it would have been Miller lite. Let the hating begin lol)
Lmfao
Lol there was Sam Adams and Blue Moon to wash it all down. (If I was buying the beer it would have been Miller lite. Let the hating begin lol)
Might as well just drink your own urine. It's cheaper.
It's been a while since this was updated, so here I go.
After the last track outing and seeing 177 mph on the top end of the track we pulled the data logs and looked to see what we had. The tune up is still on the fat side and we have quite a bit of timing pulled out of the motor still. The rpms going through the traps were in excess of 8,650! I'm not cool with that idea, haha so a rear gear change is in order. When I initially put this car together it was going to run on 30" 315 drag radials. They are a thing of the past as far as I'm concerned and the 275 Pro radials is where the game is at. Going from a 30" to a 28" tire has a huge effect on gear ratio!! I will be swapping the 3.70 gears that are currently in the car over to a 3.50 gear. I was hoping to get my hands on a 3.45 gear but they seem to be forever back ordered and Richmand has been less than helpful. So here it is sitting in the garage being torn apart. Along with the gear swap I will also be changing the rear shocks to double adjustable units from AFCO. After this is all done it's back to the track to make a 7 second pass and then set the car up to run in X275 trim and hopefully squeak out some 4.8x's in the 1/8th mile. More updates to follow in the coming days...
The undercarriage...
As far as I remember they were from All Star Performance (I double checked... The AllStar pins don't seem to have black plates. The Jegs brand pins are exactly the same but with the black plates http://www.jegs.com/i/JEGS-Performance-Products/555/90065/10002/-1?parentProductId=1714959 ) They are black anodized aluminum. The plates are anodized black as well. I used aluminum rivets to attached the plates to the hood. The snap pins are the only pieces that are not aluminum, I just wish they were black too. The car never really gets wet, I drove it once in the rain to prove a point to some naysayers but that's it. I hate hate hate rusty hood pins and when I found these it was like a dream come true, lol. I even ordered a set for my buddies Grand National and they have held up well there as well.Hey T-Top...
What hood pins are those that you're running? How are hardware pieces for rust? Ever left any of it out in the rain?
I've got a set of Mr. Gasket hood pins installed now.
They drink as much Mothers polish as the motor does, high octane pump gas.
Have you seen aerocatch hood pins at all? I am putting a set on my car and they are really nice and look very clean. I will be getting the car back from paint and will post pictures of them when i get the car back.