I had my A/C Clutch and Coil replaced under extended warranty before it ran out on my 01 Bullitt about a month ago. About 5 days ago or so the A/C would randomly stop blowing cold and blow only hot air. Then it would start blowing cold again. Well the other day I left work and it was blowing cold air, while on the way home it stopped blowing cold air and hasn't since.
I went ahead and replaced the low pressure switch since it's cheap but it didn't fix my issue. I have 12 volts coming out of the solid wire on the switch, but no voltage coming out of the blue wire with a tracer (not sure of exact color)
Now another thing I have noticed since this started is that when you turn the temp knob it pulls itself all the way over to heat after it reaches about halfway, this gets worse based on the blower speed. It fights you going back to the cold setting.
Anyone have any tips? The clutch is not engaging on the compressor, but everything seems to spin freely
I went ahead and replaced the low pressure switch since it's cheap but it didn't fix my issue. I have 12 volts coming out of the solid wire on the switch, but no voltage coming out of the blue wire with a tracer (not sure of exact color)
Now another thing I have noticed since this started is that when you turn the temp knob it pulls itself all the way over to heat after it reaches about halfway, this gets worse based on the blower speed. It fights you going back to the cold setting.
Anyone have any tips? The clutch is not engaging on the compressor, but everything seems to spin freely