building 4.6l 2v any advice?

[99Blownstang]

 

[99Blownstang]

 

[Mr. Rustypwnz]

I would run stock headgaskets myself, coppers have to be machined perfect to fully seal like they are supposed to, its pretty hard with a good tune to blow a stock headgasket.

 

[99Blownstang]

 

[cronin49]

this is my build sheet​

teksid aluminum block​

nodular iron crank​

billet steel h beam rods​

manley forged dish pistons 8.94 compression ratio​

clevite bearings​

copper head gaskets​

ARP studs​

1999 2v PI heads​

stage 1 comp cams duration @.050 226/230 lift 550​

comp cam stage 2 springs​

2.1l kenne bell 15 psi​

42lb injectors​

75mm throttle body​

90mm mass air​

billet cam spacers​

msd high output coils​

autolite forced induction plugs​

bbk shorty headers​

mmr high volume oil pan​

electric water pump​

Im sure i am leaving things out. Do you have any tips? this is my first modular build. how many ponies do you think it will be putting out?​

That's lots of $$$$$$...... $16,000 - $18,000 +.... best of luck, sounds outragous otherwise!