- Nov 28, 2006
- 172
- 0
- 0
I had the filter mounted directly to the vortech 73mm maf, bu I beleave it may have been causing turbulance, and an incorrect sample. So I fabbed up this setup. The filter is compleatly in the fender, and where the turn signal was I made a duct and scoop that channels air right to the filter "ram air" style. The silver tape is heat insulation good up to 2000* (!). That's the nitrous nozle near the end.
Total cost for the "elbow" ($15.99) Plus it's 3"ID. So no size restriction.
Just thought I'd show it off.
Total cost for the "elbow" ($15.99) Plus it's 3"ID. So no size restriction.
Just thought I'd show it off.