- May 13, 2006
- 80
- 3
- 9
I am installing new Twisted wedge 170cc heads. I cleaned up the block deck very well and pulled out the dowel pins and took them to a wire wheel on a bench grinder to clean them up. They came out very nice. I took a socket of the same size and tapped them back into the block. So I sat my aluminum head on the block and noticed that head moves back and forth towards the lifter valley approximately 1/16". Is this going to cause any problems? Should I just replace them or just bolt them on and run it? I think what concerns me is gaskets sealing and clearances. Any input is appreciated. Thanks!