Getting ready to pull my motor to install my headers correctly (390=pita) and fix a couple other things. My block is in dire need of repainting so I am going to spray it while I have it out. My engine bay is'nt too bad off but there are nicks in the paint in numerous spots so I figured while I have the motor out and I am repainting the engine I should clean up the apron and firewall and paint them as well.
What process do I need to paint the block to ensure that the paint sticks and doesn't come chipping off in a couple months like it is doing now. (Cleaning, priming, painting) Also what primer and paint is the best to use.
The same goes for the Engine Bay. I don't have a spray gun and will be doing this with a rattle can.
Any info would be greatly appreciated.
What process do I need to paint the block to ensure that the paint sticks and doesn't come chipping off in a couple months like it is doing now. (Cleaning, priming, painting) Also what primer and paint is the best to use.
The same goes for the Engine Bay. I don't have a spray gun and will be doing this with a rattle can.
Any info would be greatly appreciated.