Honeycomb Drying

Discussion in 'Mustang Sound & Shine All' started by ptim, Feb 10, 2004.

  1. ptim New Member

    Member Since:
    Dec 3, 2003
    Message Count:
    30
    Likes Received:
    0
    Trophy Points:
    0
    Does anyone have good suggestion on how to get the water from the honeycombs on the hood scoop and the front end of a 03 Mustang GT, after I wash it, it seems like they hold a gallon of water.
    ptim, Feb 10, 2004
    #1

  2. mreric New Member

    Member Since:
    Feb 7, 2004
    Message Count:
    18
    Likes Received:
    0
    Trophy Points:
    0
    blow them out with either an air compressor, or a can of compressed air used to dust out electronics. That's what I've done with other cars for shows.
    mreric, Feb 10, 2004
    #2

  3. SrK New Member

    Member Since:
    Nov 25, 2002
    Message Count:
    136
    Likes Received:
    0
    Trophy Points:
    0
    Buy an "absorber" from pepboys or autozone put it infront of the hood scoop open close hood couple of times. It should suck in most of the water if not all.
    SrK, Feb 11, 2004
    #3

  4. H8Eternal New Member

    Member Since:
    Nov 25, 2003
    Message Count:
    56
    Likes Received:
    0
    Trophy Points:
    0
    :rlaugh: I have found myself blowing Into the honeycomb grill and getting all light headed...
    H8Eternal, Feb 12, 2004
    #4

  5. Defleshed Satanic Mechanic

    Member Since:
    Nov 30, 2003
    Message Count:
    10,631
    Likes Received:
    0
    Trophy Points:
    0
    i just keep soaking it up as it comes - and i get annoyed. very effective.
    Defleshed, Feb 12, 2004
    #5

Share This Page