how many millimeters?

[hsean]

anyone with a caliper to measure what stock measurements are for the gap between the door to rear quarter and door to front fender ?

 

[wythors]

I'll be glad to do it when I get home, but it's going to be different from car to car. I'd just be shooting for "even".

 

[hsean]

I'll be glad to do it when I get home, but it's going to be different from car to car. I'd just be shooting for "even".

thanks for the help i do this for a living at ford with all closures .i had to replace the the doors on my build and i am wondering if i have to shimmy the bottom hinge.

 

[wythors]

Alright, I measured the doors of the two cars that are currently in the garage. All four doors were within a couple of 100ths of 4.75 mm, as measured at the body line above the body side molding.

 

[hsean]

Alright, I measured the doors of the two cars that are currently in the garage. All four doors were within a couple of 100ths of 4.75 mm, as measured at the body line above the body side molding.

wow that is a huge margin i was hoping to go fours all the way across but the fender gap would be to wide.thanks for the info makes sense,

 

[hsean]

just curious what the fender to door looks like i am going to guess about the same .i have the doors at 3 just eyeing it and the fender to door margin is pretty wide.

 

[wythors]

That 4.75 was both front and rear of the door on each side. They were pretty much equal both front/rear and left/right.

 

[hsean]

thanks again