I am the recent new owner of my 3rd 5.0 and have a HP question that I hope someone could give me help with. The car I bought is a 92 LX coupe with a new motor that was put in in Jan '05 (I have the receipts). here is what it came with...
302 block bore to 306
hydraulic rollers
1.7 RR's
B303 cam
RPM performer heads
RPM performer intake
MAC shorty headers
MAC H pipe
MAC mufflers (dont know what model but they are VERY loud)
holley 750 DP
MSD 6AL ignition.
4:10 gears
HD T5 tranny
couple of questions...
The builder of the motor (Bob's Speed Products in FT. Lauderdale) said that it had 375 Hp and 350 Lbs. Torque (not rear wheel) does this seem right?
With this set up, and running DR's, what could i expect to run in the 1/4. The guy i bought it from showed me two time slips that he said were his one said 11.86 and the other 11.80 (close friend of my best friend so I beleive they were his).
With this motor set up, would i benefit at all from long tubes and/or and X-pipe?
thanks to all who respond.
302 block bore to 306
hydraulic rollers
1.7 RR's
B303 cam
RPM performer heads
RPM performer intake
MAC shorty headers
MAC H pipe
MAC mufflers (dont know what model but they are VERY loud)
holley 750 DP
MSD 6AL ignition.
4:10 gears
HD T5 tranny
couple of questions...
The builder of the motor (Bob's Speed Products in FT. Lauderdale) said that it had 375 Hp and 350 Lbs. Torque (not rear wheel) does this seem right?
With this set up, and running DR's, what could i expect to run in the 1/4. The guy i bought it from showed me two time slips that he said were his one said 11.86 and the other 11.80 (close friend of my best friend so I beleive they were his).
With this motor set up, would i benefit at all from long tubes and/or and X-pipe?
thanks to all who respond.