MSD Tach Driver

Discussion in 'SN95 4.6L Mustang Tech' started by GettinThere, Jul 2, 2008.

  1. GettinThere New Member

    Member Since:
    Jul 29, 2005
    Message Count:
    563
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Central Texas
    I've searched but haven't found what I'm looking for. Does anyone have an MSD Tach Driver (PN 8913) installed? How exactly did you wire it?
    GettinThere, Jul 2, 2008
    #1

  2. GettinThere New Member

    Member Since:
    Jul 29, 2005
    Message Count:
    563
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Central Texas
    bump
    GettinThere, Jul 7, 2008
    #2


    Sponsored Ad

  3. Stark77 New Member

    Member Since:
    Jun 11, 2008
    Message Count:
    503
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Tallahassee, FL
    I have it - new in the box! hahaha - I've been reading the manuals in the bathroom at home, becoming very familiar lol. I will be hooking that up to my RPM activated switch.
    Stark77, Jul 7, 2008
    #3

  4. StangYellow Founding Member

    Member Since:
    Sep 12, 2002
    Message Count:
    1,052
    Likes Received:
    0
    Trophy Points:
    36
    I call it "taking care of paperwork"

    There are ignition wires on the passengers side of the firewall, but I do not know which wires you need to splice into. But thats where the tach driver should be mounted to.
    StangYellow, Jul 8, 2008
    #4

  5. Stark77 New Member

    Member Since:
    Jun 11, 2008
    Message Count:
    503
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Tallahassee, FL
    On the tach driver - I believe the red/black striped wire is mated with the negative side of the main coil plug ( pick either the drivers or passenger side). There is also one that "can" be spliced into the wire that sends signals to the tach. Unfortunately, all of their manuals are designed to teach you how to set it up for a shift light.
    Stark77, Jul 8, 2008
    #5

  6. GettinThere New Member

    Member Since:
    Jul 29, 2005
    Message Count:
    563
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Central Texas
    Bump.

    Did you install it yet? If you did, and it works well, please post back about how you wired it up. Thanks.
    :flag:
    GettinThere, Jul 28, 2008
    #6

  7. BannonJr Member

    Member Since:
    Aug 12, 2006
    Message Count:
    237
    Likes Received:
    0
    Trophy Points:
    16
    Location:
    St.Lazare Quebec
    do you have MSD 8918 in that pack? If so, it clips right on to a coil pack positive
    BannonJr, Jul 29, 2008
    #7

Share This Page