Mustang 4.6 70mm BBK Throttle Body and Trick Flow Plenum

Discussion in 'Engine and Power Adder Parts' started by RickieFrat, Nov 5, 2009.


Find More Mustangs For Sale!

  1. RickieFrat

    Founding Member

    Joined:
    Aug 14, 2002
    Messages:
    328
    Likes Received:
    0
    Trophy Points:
    17
    Location:
    State of Corruption - Providence, R.I. , USA
    SOLD !!!!!!
     
    #1
  2. StanginSean

    StanginSean New Member

    Joined:
    Aug 19, 2008
    Messages:
    23
    Likes Received:
    0
    Trophy Points:
    1
    I may be interested. Is 70mm fine for an N/A car with a few mods? and whats the mileage like on these?
     
    #2
  3. RickieFrat

    Founding Member

    Joined:
    Aug 14, 2002
    Messages:
    328
    Likes Received:
    0
    Trophy Points:
    17
    Location:
    State of Corruption - Providence, R.I. , USA
    70MM is great with a n/a car, I was told not to go bigger than that. Both units were on his car just over a month and it was a garage queen that was rarely driven. He noticed a difference with them both on his car.

    Even looking inside the plenum to can tell that it is clean. I tried snaping a pick but it would not focus right.

    The adjustment screw on the TB needs to be adjusted for the proper RPM. He had it set for a Procharger and it needs to be backed down. He tossed a rod with the Procharger - sold the blower and installed a new bottom end with the KB. so now with him having a Kenny Bell - he has no need for it.
     
    #3

Share This Page