Polished 5/8" CPR fuel rails

Discussion in 'Engine and Power Adder Parts' started by CobraRed_96_GT, Sep 25, 2009.


  1. CobraRed_96_GT

    CobraRed_96_GT Active Member

    Joined:
    May 20, 2006
    Messages:
    1,651
    Showcase:
    2
    Albums:
    1
    Likes Received:
    1
    Trophy Points:
    39
    Location:
    UCSD/La Jolla
    Have 5/8" billet aluminum 2V fuel rails for a returning system. Sanded/eliminated the anodizing. Did sanding and light buffing/polishing. Reason i did light over mirror/chrome finish is because parts that are chrome finish in hard to dust/clean places instatly and always look dirty and crappy. I prefer a bright metal shine for rails.

    Out of box:
    [​IMG]

    No more anodizing:
    [​IMG]

    After buffing:
    [​IMG]

    Done:
    [​IMG]

    [​IMG]
    [​IMG]

    [​IMG]

    [​IMG]

    The bolt securing tabs are mainly just billet aluminum shine:
    [​IMG]

    $95 shipped
     
    #1

Share This Page