power drop

Discussion in '2.3L (N/A & Turbo)' started by Ni4Ni3022, Oct 18, 2004.

  1. Ni4Ni3022 New Member

    Member Since:
    Jun 17, 2003
    Message Count:
    75
    Likes Received:
    0
    Trophy Points:
    0
    i just finished my swap and have noticed once i hit about 4grand there is no power whatsoever... i have been shifting at 4 grand when im trying to make it go fast... i dotn know if its because of the stock IHI turbo or what!!!! i do have a 2.73 rear...that hurts alot. Why does it have no power gain after 4g?!?!? my cam is for 1800-5900rpm range power,, so it isnt doing much good right now.

    Ps anybody have any 3.73 or higher 8.8 gears they wanna sell me?

    -thanks ,

    Mike
    Ni4Ni3022, Oct 18, 2004
    #1

  2. Stinger Founding Member

    Member Since:
    Jul 7, 2001
    Message Count:
    7,726
    Likes Received:
    0
    Trophy Points:
    0
    I don't know...does it fall on it's face, cut out, sputter, etc. or just not pull quite as hard? The stock turbo motors where fast when shifted at about 5 grand.
    Stinger, Oct 19, 2004
    #2

  3. bhuff30 Founding Member

    Member Since:
    Dec 11, 2001
    Message Count:
    5,751
    Likes Received:
    2
    Trophy Points:
    78
    double check the cam timing. It may be off a tooth.
    bhuff30, Oct 19, 2004
    #3

  4. mr_woodster New Member

    Member Since:
    Jul 28, 2003
    Message Count:
    1,316
    Likes Received:
    0
    Trophy Points:
    0
    When did it start? has it always been like this? What cam do you have in it? Whats your setup?
    mr_woodster, Oct 19, 2004
    #4

  5. T3AL New Member

    Member Since:
    Oct 17, 2004
    Message Count:
    216
    Likes Received:
    0
    Trophy Points:
    0
    When i spun a main/crank barring I had no power at 3K RPM's and it slugged to 3K.
    T3AL, Oct 20, 2004
    #5

Share This Page