pro kit update

Discussion in 'SN95 4.6 Talk' started by streethorse, Apr 3, 2007.

  1. streethorse Active Member

    Member Since:
    Oct 8, 2005
    Message Count:
    1,000
    Likes Received:
    1
    Trophy Points:
    38
    After 2 weeks I think the springs have setteled as much as they are going to.
    I ended up getting a 3 eights inch drop in front and 7 eights inch drop in back.
    If the front dropped the same as the back , I would be totaly satisfied.
    Now the front looks either level or slighty to high...... whats your opinion,
    should I do something or stick with what I got.
    [IMG][/IMG]
    streethorse, Apr 3, 2007
    #1

  2. flyboy86 New Member

    Member Since:
    Dec 5, 2006
    Message Count:
    114
    Likes Received:
    0
    Trophy Points:
    0
    Looks good to me. I'm happy with my pro-kit, however, I took the isolaters out, and I think I got a little more drop. You could take the iso's out in front, it may level it out a bit.
    flyboy86, Apr 3, 2007
    #2

  3. BennyBlown2v New Member

    Member Since:
    Dec 10, 2004
    Message Count:
    1,294
    Likes Received:
    0
    Trophy Points:
    0
    take the front isolators out, that's what I did when i ran pro-kits.
    BennyBlown2v, Apr 3, 2007
    #3

  4. streethorse Active Member

    Member Since:
    Oct 8, 2005
    Message Count:
    1,000
    Likes Received:
    1
    Trophy Points:
    38
    I reused to stock isolators, how much more drop would I get without them?
    streethorse, Apr 3, 2007
    #4

  5. flyboy86 New Member

    Member Since:
    Dec 5, 2006
    Message Count:
    114
    Likes Received:
    0
    Trophy Points:
    0
    I don't know exactly, but when they're not installed, the rubber is prolly just under half an inch thick, so installed with the weight of the car on them, I'd assume just a little less than that.
    flyboy86, Apr 3, 2007
    #5

Share This Page