Last weekend I made an attempt to install my subframe connectors, and hit a snag. I'm hoping someone on here has installed these and can offer some insight. Basically, the front subframe on the II has a short section at the very back that hangs a little lower than the rest, and is rounded. When the connectors are installed, this portion bottoms out inside the frame of the connector, preventing them from lining up at the front end of the connector by about 7/16" of an inch.
The only way I can see to line everything up is to cut open the bottom of the connectors to allow the subframe to protrude through just slightly. That seems, well, wrong... I can't help but wonder if I've done something wrong, but I can't see what it would be.
Any thoughts?
The only way I can see to line everything up is to cut open the bottom of the connectors to allow the subframe to protrude through just slightly. That seems, well, wrong... I can't help but wonder if I've done something wrong, but I can't see what it would be.
Any thoughts?