wide band o2 question

Discussion in 'Fox 5.0 Tuning' started by mtlman22, Jul 21, 2008.

  1. mtlman22 New Member

    Member Since:
    May 14, 2005
    Message Count:
    87
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    NY
    i am looking into purchasing a wide band o2 kit and i just want to know your guys thoughts on going with a dual channel kit or stick with your typical single Ch.??
    mtlman22, Jul 21, 2008
    #1

  2. millhouse Founding Member

    Member Since:
    May 14, 2002
    Message Count:
    2,074
    Likes Received:
    0
    Trophy Points:
    46
    Location:
    Simpsonville, SC
    Can you tune each bank individually? If not, then just stick a single in the known lean bank (usually the drivers side).
    millhouse, Jul 22, 2008
    #2

  3. mtlman22 New Member

    Member Since:
    May 14, 2005
    Message Count:
    87
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    NY
    well both banks are pretty much lean! no each bank cannot be adjusted seperatly only as a ""Global" adjustment
    mtlman22, Jul 22, 2008
    #3

  4. millhouse Founding Member

    Member Since:
    May 14, 2002
    Message Count:
    2,074
    Likes Received:
    0
    Trophy Points:
    46
    Location:
    Simpsonville, SC
    In that case, getting a dual bank setup is going to be a waste of money. Keep in mind that most every tuner that is going to burn a custom chip uses a single wideband in the driver’s side exhaust.
    millhouse, Jul 22, 2008
    #4

Share This Page